Jump to content
Welcome Guest! Please read more information about our club!

Blog EuroDat

A blog by EuroDat in Member Blogs

  • Entry

    1

  • Comments

    3

  • Views

    1,966

About this blog

Making an inspection light lens

The inspection light is is NLA or very hard to find at the least, so I decided to try and make the lens. I had a light in good condition, but the lens was brittle and badly faded. Since I had all the equipment for making a set of tail light lenses for my 280Z it was not too much work to try make the inspection light lens. The Equipment I used: 1. Vacuum chamber and vacuum pump. This is needed to remove air from the silicone resin used for the mould and the clear resin used to make the lens. You
EuroDat

Important Information

By using this site, you agree to our Privacy Policy and Guidelines. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.