1970 240Z Floor Tar Mat Templates 1.0.2

Awesome!  Any chance you have the same for the mats over the tranny tunnel?

I do plan to make templates for that area and the rear floor as well, but I can't commit to a time yet.

Cheers, Mike

Does the dwg file have the printing parameters set up?

Sorry no, I don't have access to AutoCad. I exported it to .dwg from the 3D cad software that I use, Solid Edge. I used an export setting of 1:1 and the sheet size is 36" wide x 72" long. The drawing has a few dimensions so that you can confirm that when printed it is to the correct scale.

46 minutes ago, CanTechZ said:

Sorry no, I don't have access to AutoCad. I exported it to .dwg from the 3D cad software that I use, Solid Edge. I used an export setting of 1:1 and the sheet size is 36" wide x 72" long. The drawing has a few dimensions so that you can confirm that when printed it is to the correct scale.

Thanks for the info. I have AutoCAD, but my printer is 24", so I'll have to take a look, and see if I can configure a print file to make it work.

Cheers,

Racer

8 hours ago, CanTechZ said:

Sorry no, I don't have access to AutoCad. I exported it to .dwg from the 3D cad software that I use, Solid Edge. I used an export setting of 1:1 and the sheet size is 36" wide x 72" long. The drawing has a few dimensions so that you can confirm that when printed it is to the correct scale.

I just pulled it up in AutoCad and it loads perfectly, and to-scale.  Excellent!

I love that you posted both pdf and dwg. I have autocad and the dwg is so much easier to manipulate for printing

Charles

10 hours ago, Patcon said:

I love that you posted both pdf and dwg. I have autocad and the dwg is so much easier to manipulate for printing

Charles

Happy to hear that you found it useful.

On 8/20/2023 at 8:52 AM, CanTechZ said:

Happy to hear that you found it useful.

I had an issue,

I opened the front floor DWG in Autocad LT no problem but I couldn't open the other two DWG's. "Drawing was created in an Incompatible version"??

I can't figure out how to plot portions of the PDF's because of my 24" plotter size

I Figured it out, I can use the poster setting with a 1" overlap and that will print it for me out of Acrobat

Thanks again for the effort to publish these!

C