Interior
Discussions about the interior components of your early Zcar.
2,371 topics in this forum
-
- 2 replies
- 1.2k views
Here are are some pictures of a rear strut bar I had a local fab shop make. It was built by Tolle Fab in Sacramento 916-524-5315.
Last reply by Miles, -
-
- 2 replies
- 4.7k views
I am looking for a nice set of black 300ZX seats to put in my 73 240Z. Does anyone know if any mods are needed to install the 300ZX seats? Where would be a good place to look for them besides ebay.
Last reply by SteveJ, -
- 0 replies
- 1.2k views
I need to to replace the control graphic on my 260 heater control panel I printed the image on sticky vinyl and then put it on a peice of plexiglass. It worked well. here is the graphic if anyone else would like to use it.
Last reply by graham53, -
- 0 replies
- 1.1k views
If anyone needs seats i am trying to sell these. I dont know how much shipping would be but im not looking to get too much for them.
Last reply by dade280, -
- 1 reply
- 1.2k views
are these knobs with silver inserts common? i can't recall seeing any other than my own. oct 71 built date.
Last reply by Zak's Z, -
- 2 replies
- 1.6k views
Anyone have a set of these seats installed? I've read about problems with the brackets and seat height in the past and wasn't sure if anyone had successfully installed a set.
Last reply by ta240, -
- 7 replies
- 1.8k views
Any other sources for nice looking carpet mats? I almost bought a set from MSA but the logos actually seem like a bit much to me, I'd prefer a bit more subtle but don't really want the complete plain ones. -Trevor
Last reply by TomoHawk, -
- 15 replies
- 2.5k views
Well i don't mean to sound too dumb but I was wondering how the two seperate pieces of the seat belt come together. If someone could post a picture i would gladly appreciate it.
Last reply by hd240z, -
- 4 replies
- 1.6k views
Thought I'd post some pictures of my seats that just got redone. I got the MSA original style seat covers and had them professionally put on and also had them rebuild and add foam on the inside them, especially the driver side which was the worst and pretty much shot. It's a big improvement over the old worn out ones and love the way they feel and turned out!
Last reply by 76Datsun280z, -
- 2 replies
- 1.6k views
Has anyone ever used Hurculiner as a sound deadener and a rust proofer? I am putting Second Skin in my 240Z to quiet things down and lesen the heat. Someone told me that Hurculiner on the floor pans and the rear deck with seconf skin on top work well together. I am just concerned about the Second Skin sticking properly to the rough Hurculiner. Any words of wisdom? Brad
Last reply by Bulldog Z, -
- 0 replies
- 1.2k views
Replacing the dealer AC with factory AC and I am having questions about the AC lines. What angle are the ends of the lines? Are they 45 degree or 37 degree. I am putting in custom lines (stainless steel braided) and have the ability to change the ends.
Last reply by 280~Master, -
- 5 replies
- 1.4k views
Hello My 1971 240z Came to me without much of an interior. The original exterior color is white. It came to me with white bucket seats. What else should or shouldn't be white (door panels, vinyl trim,etc)? I have seen pics of white seats with everything else black and pics of white seats and white door panels, everything else black. Are either of these trim combinations correct? Any advice welcome. Thanks
Last reply by jerbear,
-
Recently Browsing 0 members
- No registered users viewing this page.
Yarb
