Interior
Discussions about the interior components of your early Zcar.
2,371 topics in this forum
-
- 14 replies
- 3k views
Hey Z nuts, does anyone have any "bright" (pun intended) Ideas on making my dash gauges brighter? My spedo and tach are great but my other three gauges a pretty dim. are there any other type of bulbs out there? More watts? Any tricks to make them look brighter, and no I dont want to put on white faces. by the way im rollin in a bitch'n 72 240. I dont even know what kind of bulbs are in there now. Matt-
Last reply by aRCH-Z, -
-
- 3 replies
- 1.3k views
Hi All, Due to an unfortunate misunderstanding my gear gaiter is now in the possession of County Waste Disposal Dept. so I need to get hold of a new one. I'm going to get a local trimmer to knock up a leather one for me to match the steering wheel he's re-trimming at the moment but I need the dimensions. Any one know them or has their gaiter handy to measure from? See cunning image attached for dimensions I need. I'm assuming the 't' is the same for all 4 sides. Cheers, Rob
Last reply by sblake01, -
- 2 replies
- 1.7k views
I am looking for screws that hold the interior panels on the inside of the car. I was wondering if anyone knew what size they were. Thanks
Last reply by EScanlon, -
- 37 replies
- 5.2k views
After doing some tests on my current seatbelts I found that they are very dangerous as the shoulder strap sits too low and past my shoulder edge and below my H point. Simulating a sudden stop my body slides off the seatbelt towards the left. Not the desired effect. Rather than fixing the current x amount of year old belts I decided to buy a racing harness for both the driver seat and the passanger seat. I settled on the Racers Choise Inc (RCI) 3" 5 Point Latch type belts. Btw, Brett, they are on sale now from Rare Spares if you are after a set.
Last reply by kmack, -
- 5 replies
- 1.4k views
Quick question: When a steering wheel is said to be "14 inch diameter", what does that mean exactly? Is it the absolute measurement from the rim outside to outside, or is it the diameter from the center of the rim on one side to the center of the rim on the other. I'm trying to compare aftermarket wheels to the OEM wheel on my 1978 280Z. The OEM wheel is 15" from outside to outside, or 14" from the center of the rim on one side to the center of the rim on the other. Anybody know? Thanks.
Last reply by mdbrandy, -
- 2 replies
- 1.5k views
Anyone out there know where to buy (in the US) the Jute material that goes under the carpets? I would like to get it as close to original as possible. TIA, Marty
Last reply by Marty Rogan, -
- 3 replies
- 1.8k views
Hi group, I read posts daily but, 'till now, haven't participated much. I have an early '71 Z, pretty much restored to (concours?) original and need a resource for the plastic fasteners that hold the front rubber door/window post seals to door body. Also, need the fasteners to attach the lower door rubber splash guards to bottom of doors. If anyone can lead me to a source for these fasteners, it would be greatly appreciated. While I am here, does anyone have the small seals that fit in the upper foreward corner of the quarter windows? They are a small rubber, T-shaped seal that seals the upper rear corner of the door window frames and the upper forward corner of th…
Last reply by AZ-240z, -
This is addressed to our members who don't reside in the U.S. as I've not met nor heard from anyone in the U.S. who has seen one. In fact probably Alan in the U.K. will know. Thanks in advance. The Fog Lamp Switch, the one that is supposed to mount above the cigar lighter on 70 through 72 240 Z's, does anyone have a picture of what it looks like? Better yet, anyone have a spare one they're willing to sell? I'll pay the shipping! Any information would be appreciated.
Last reply by dspillman, -
- 5 replies
- 1.6k views
I just removed my dash to get it restored and the glovebox disintergrated. Any suggestions for effective replacements?
Last reply by viparz, -
- 1 reply
- 1.3k views
My 1971's Heater Panel reads ... AIR Off --- Vent --- Heat TEMP Off -------------- Heat DEF Def ------------- Room I didn't realize there was a difference and I bought one the reads ... AIR Off --- Vent --- Heat TEMP Cold ------------ Heat DEF Def -------------- Floor Can anyone explain? Although the words are different it seems that their meaning is the same. Can I use the one I bought in my place of the old one?
Last reply by EScanlon, -
tan interior pics? 1 2 3
by halz- 25 replies
- 4.3k views
Does anyone out there have pictures of an original 240Z with a tan interior? I'd like this to help me when recovering the seats of my '73 model. I think I remember one of the original 240Z sales brochures having a car with a tan interior..?
Last reply by 77 Z, -
how difficult is it to remove the clock in a 1970 240Z? Does any one recommend a reliable place to send the old clock for repair? thanks RobertH Lakeland, Florida
Last reply by EScanlon,
-
Recently Browsing 0 members
- No registered users viewing this page.
