Interior
Discussions about the interior components of your early Zcar.
2,371 topics in this forum
-
- 6 replies
- 3.2k views
I need to do a little repair work on my interior panels. I have a plastic welder and want to try and fix some cracks, but I need to know what the original plasitic is. Does anyone know is it Polypropelene or ABS or PVC? Thanks Steve
Last reply by NVZEE2, -
-
- 6 replies
- 1.7k views
I'm not sure if this is normal for these quirky old cars, so I figured I'd ask before I start tearing into things. (I almost took my door apart once since I couldn't lock it with the door open ) Anyway, my heater works to my expectations for a car that recently had its 40th birthday, but heat only comes out the defrost or floor. I'm guessing that's normal, since the heater panel only says those options. This wouldn't bother me so much but the dash vents ( the round ones on each side, and the rectangular one in the center ) continue to blow cold winter air on my hands while I drive. Should they blow hot, too? Or should the not blow at all when the heat is on. Just somet…
Last reply by Chickenman, -
- 1 follower
- 0 replies
- 824 views
Called jegs but couldn't get an actual answer or blue prints of the dimensions of the tubing. Does anyone know if the A-pillar tubing run behind the dash or does it run in front of the dash where the dash wouldn't need to be removed?
Last reply by Will Thammavongsa, -
- 1 follower
- 0 replies
- 897 views
Can anyone recommend a shop that sells replacement gauges? I've looked at autometer, but I didn't know if someone out there sold a set specific for the Z. Thanks!
Last reply by CEgg11, -
- 7 replies
- 1.6k views
My 1971 240 only has one speaker in the left rear, the same mounting holes are on the right side but no speaker, also on the left there are wires in the wiring harness, none on the right. The knob behind the on/off volume knob seems to be balance. The previous owner had installed 4 speakers (2 on kick plates and 2 behind seats). I'm trying to get back to original. Can anyone help with this? Thanks in advance.
Last reply by ericjump, -
- 7 replies
- 2.4k views
hello Z people, i need to replace the shock tower vinyl on my '70 Z, anybody have recommendations for aftermarket suppliers? Thanks, Ken
Last reply by TomoHawk, -
- 2 replies
- 1.5k views
I just realized that MSA is selling replacement interior panels (perhaps they've been selling them for a while, but I never noticed). They're pricey, but I was wondering if anyone had ordered some and could comment on the quality of the parts? Also, if someone has ordered multiple panels, how consistent is the colour? http://www.thezstore.com/page/TZS/PROD/classic08j08/40-3634 http://www.thezstore.com/store/merchant.mvc?Screen=PROD&Store_Code=TZS&Product_Code=40-3748 http://www.thezstore.com/store/merchant.mvc?Screen=PROD&Store_Code=TZS&Product_Code=40-3507 http://www.thezstore.com/store/merchant.mvc?Screen=PROD&Store_Code=TZS&a…
Last reply by Bonzi Lon, -
- 1 follower
- 18 replies
- 13.7k views
Anyone know if the replacement seat foam for a 240 seat will also fit a 280 seat? I'm ordering a seat cover kit from Les Cannaday at Classic Datsun and need to replace the foam on the drivers seat. The foam they carry is only specified for 240 seats.
Last reply by Patcon, -
- 2 followers
- 11 replies
- 1.8k views
What do you guys use to treat/protect/clean interior plastic? Dash board, console, diamond pattern final, door panels, is it as easy as Armor All? Or is there some stuff that you have found that does a better job? Thanks, Eric
Last reply by Captain Obvious, -
- 1 follower
- 16 replies
- 6.7k views
Hi, would anyone know where I can get a replacement dashboard vin tag? The PO sent out the dash to get recovered and I can't find the tag anywhere in the dozens of boxes. I have the other tags. Thanks!
Last reply by ZCurves, -
- 8 replies
- 2.1k views
I've been working on some AC and heater control and plumbing issues. I'm starting to re-attach some of the wiring, and I've hit a snag. I believe the control in the picture is the thermostat switch for the AC. It has two terminals. The harness pictured has a yellow and a "blue" wire. Can someone tell me if the yellow wire goes on the right or left terminal of the switch? The answer would be great. Some insight on how I could have figured it out would be even better. Thanks for the help.
Last reply by cgsheen1, -
- 1 follower
- 4 replies
- 1.4k views
The seats in my 78 are ripped and sagging. I have a towel over the driver's side bucket to keep from sticking to the duct tape the PO mended it with. I want to have them rebuilt/recovered properly but I can't afford it now. Are those cheap seat covers from the auto parts stores worth buying as a temporary solution? I thought of getting some fake sheepskin covers or maybe something made of neoprene so they don't slide around. Any recommendations?
Last reply by bvolken,
-
Recently Browsing 0 members
- No registered users viewing this page.
