Interior
Discussions about the interior components of your early Zcar.
2,371 topics in this forum
-
- 2 replies
- 1.7k views
I have two questions regarding seats in a '72 240Z: 1. Can the seat bottoms or backs be swapped from driver's side to passenger's side? 2. Right now my passenger's seat has two brass grommets in the lumbar area, but the driver's side has none. Is this correct? Thanks for your input on this. Gary
Last reply by d240zx2, -
-
- 3 replies
- 1.6k views
I can't get my blower motor to work. I am a new z car owner. This car has been in my family since 1974 my family is the second owner and I am the third generation driver. I have been through the manual for the car that my grandpa bought in the late 70z. Most detailed book I have ever seen for not being a FSM. I can't seem to figure it out. Could you guys help me.
Last reply by neo126, -
- 0 replies
- 1.3k views
I think that while the engine is out, I'll grab the speedometer and get the face off and see if I can brighten the odometer wheels. The wheels are kinda dirty and it's hard to read the numbers even during the daytime. The speedometer ring number could probably use a little brightening too. Has anyone tried this? I'm wondering if there are any kinds of cleaners that would help, or if there are any cleaners or solvents I should avoid using. I promise to leave the odometer wheels at the current values! :tapemouth it's already at 23,000 anyway :pirate:
Last reply by TomoHawk, -
- 2 replies
- 1.2k views
I am trying to decide how I want to set my 240 up sterieo wise. I am not at all into the whole car system thing and mostly only listen to news radio, country station or my ipod. The PO had a aftermarket cd player installed with 2 6x9's installed on the rear deck in blocks of carpeted wood. The speakers look pretty stock like so I am leaning toward keeping them. Up front I have no other speakers so I was looking at those kick panals with built in speaker pods that someone on the site makes but may just run the wires to the kick panal and add speakers at a later date. My big debate is what to do with the head unit. A friend gave me a fancy sony head unit with a Ipod control…
Last reply by Travel'n Man, -
- 31 replies
- 6.3k views
Can anyone post pics of weather stripping on the S30 doors? The only piece's I have left on my doors are the very bottom, underneath, and the very top of the window channel that meets the body. I am missing the ones that wrap around the window channel (front and back) where the channel meets the door. And the one that sits just inside close to the dash and top door hinge. The one that is held in place with 3 rivets. Those pics would be appreciated. Thanks.
Last reply by Willoughby Z, -
- 1 reply
- 1.4k views
how does the outside window seal (with the rubber) come off? Thx Asa
Last reply by tlorber, -
- 5 replies
- 1.7k views
Rec'd my new window frame felt today from blackdragon, can't get it in right. Anyone done this job? Any help will be appreciated. Thx
Last reply by KAL7467, -
- 11 replies
- 2.6k views
Does any one have a picture of a door panel and the piece to the rear of it, (the piece that is clipped to the dog leg?) Ideally I would like to dee the two together without a seat in the car, but I'll take what I can get. I'm going to repaint the panels 2 tone and I need to figure out where the boundaries should be for each color. Also, any new ideas for the chrome strips in the door panels? One of the posts I read said to use a 3/8" adhesive strip from an auto parts store. I was only able to locate 1/4 ", which is not wide enough. Thanks.
Last reply by Reverend, -
- 15 replies
- 5.3k views
I am installing the Roadster seatbelts from Wesco into my 1971 240z. I had the MSA shoulder belts in and did not like them at all. My question is about he upper mount to the retractor end. I'd like to know what people do there. Spacers? Short bracket to get it facing in the right direction? Simply bolting it into the hole at the top of the pillar doesn't seem to be right. Thanks all. mark
Last reply by woytovich, -
- 1 reply
- 1.3k views
My current seat situation: drivers seat is okay but a bit dirty. I've tried to clean it with some specified seat-cleaning products but there is always some dirt in the grooves, which makes it look bad. Passenger seat is busted and needs new covers. Is there any superduper product i can use to get rid of the dirt?
Last reply by Marty Rogan, -
- 1 reply
- 1.5k views
Does anyone know a source for replacement defrost hoses for 1970-73 Z? These are the ones that run from the heater box to the vent at the top of the dashboard.
Last reply by LostxSoul, -
- 6 replies
- 5.8k views
Hello RE: Choke Cable Lever Mounting Bracket I was wondering if anyone has installed something like this before on there 240Z and found it helpful vs mounting the lever to the console. I was one of the folks that had to mount the choke lever to the center console. I found this on ebay. Click link: http://www.ebay.com/itm/270919960660?_trksid=p5197.c0.m619 Thanks Larry
Last reply by manny1973,
-
Recently Browsing 0 members
- No registered users viewing this page.
Yarb
