Open Discussions
Open discussions about the early S30 series issues and topics.
8,810 topics in this forum
-
Oil pump 1 2 3
by ennisdavis- 3 followers
- 31 replies
- 2.9k views
4 bolts hold the oil pump on, right? Used heat, thing is stuck.
Last reply by jonbill, -
-
- 4 followers
- 42 replies
- 5.9k views
Hi all, I installed an MSD ignition in my '72 Z, and now the alternator is way under-spec-ed. Battery dead after 10 minutes of driving. I installed a new 70amp alternator from z car depot, and have one question about the factory harness. there's a 2 pin harness that runs to the old alternator location. the new has a tab labeled "ignition key on". I believe I'll need to manually wire this lead to one of the two pins of the car's harness. i can't tell if its the yellow wire, or the white/black wire. Any help would be appreciated. I found this data point on the 280z: F&N (T connector) N (Yellow) (on the early alt becomes the Sense signal on the newer …
Last reply by RJK, -
- 1 follower
- 2 replies
- 633 views
On: new of top gear: New build of 240z rallycar with L24 !! ( made bigger to 2800cc and special head and 3 webers. also the Kobe-Seiko 16" Z432 wheels. And to finish it a nice sounding exhaust..) Sorry this is in Dutch.. that language the dutch use is Netherlands eh.. dutch yeah complicated hey.. hollands.. although thats not the same haha.. Sung Kang (Han) bouwt een Datsun 240Z-rallyauto (msn.com)
Last reply by dutchzcarguy, -
- 2 followers
- 2 replies
- 735 views
Was at a garage helping out sorting/tagging all the Z parts for a widow for selling them and came across a smashed dash. Didn't think anything of it at first, then pulled it down from above and saw the gauges didn't smashed, so added it to my parts pile. Got home and saw what vin# it was and was pretty surprised of the low vin. Pulled the gauges and harness then added them to my collection.
Last reply by siteunseen, -
- 0 replies
- 636 views
https://www.carbuilder.com/uk Their inventory is so extensive that I think it might be worth the extra shipping.
Last reply by grannyknot, -
R200
by ennisdavis- 2 followers
- 3 replies
- 691 views
Did all 75' S30s with manual trans come with the R200?
Last reply by Zed Head, -
- 2 followers
- 4 replies
- 778 views
Do the door sills sit flush on the rockers or is there a slight gap where i can weld patches on the rocker?
Last reply by dutchzcarguy, -
- 3 followers
- 6 replies
- 1.3k views
Hello i am just back from the AACA Eastern Fall Meet at Hershey, PA. I entered my Z in the Historical Preservation Original Features class. In that class you are judged against a standard of originality. Anything restored or incorrect aftermarket gets a deduction. Used, NOS and OEM replacement parts are allowed. Owners are asked to disclose anything they know has been restored or modified. You are allowed up to seven deductions. Under that and you qualify for a HPOF award. My car is pretty much original but has had two minor body repairs/paint and the fuel line in not totally correct (correct routing but a new piece near the filter has been replaced using a Unio…
Last reply by VaCat33, -
- 3 followers
- 10 replies
- 1.4k views
Found these in the oil strainer. Magnified one and its the shape of an isosceles trapezoid. Size of a tooth pick tip. Magnetic. Its not shrapnel because it has a formed shape.
Last reply by Ninjaneer11, -
- 3 followers
- 14 replies
- 1.2k views
Hello fellow Houston Texas area Z owners. I have cleared out my storage unit and I will be liquidating some of my excess Z and roadster parts. Keeping what I deem critical. I have a recently rebuilt type B 4 speed with about 2000 miles on it. I have a 1971 Z orange airbox I have a polished manifold for SU's I have a like new Cannon manifold for some Webers that I ran for a while and looks good. Have a 1971 Z radiator in good shape as well. Have many sets of spark plug wires and other odds and ins as well. I have a couple of distributers and ballast resisters. If any Houston area Z owners are in need of anything, Mos…
Last reply by Wally, -
- 3 followers
- 5 replies
- 1k views
Pulled the dash to install LED's and upgrade harnesses.. and clean ha... per the usual I have an extra piece that I did not track on the take down. does anyone know this piece??
Last reply by nolan schwartz, -
- 6 followers
- 55 replies
- 8.9k views
I sure hope VP Pence gets this Corona virus under control before ZCON.
Last reply by zspert,
-
Recently Browsing 0 members
- No registered users viewing this page.
Yarb
