Open Discussions
Open discussions about the early S30 series issues and topics.
8,810 topics in this forum
-
- 3 followers
- 9 replies
- 944 views
74 260, tach light and heater panel lights work.. no speedo or all 3 gauges/clock not on... does this mean is just dead bulbs if tach light works ok? or can it be something else? also turn signal lights dont work, or e brake light... are they just all dead??
Last reply by Jeff Berk, -
-
- 3 followers
- 11 replies
- 1k views
I have now removed the horn relay from way way up top. not seen in photo.. now im trying to figure out what the other ones are.. i know one is fan, one is defrost one is wiper.. whats the other and which is which.. the images in the fsm are totally wrong..can ya help me out..?? thanks
Last reply by Shawninvancouver, -
- 22 followers
- 321 replies
- 39k views
I started working on the front suspension of my car and found some rot that looks structural. I have never really worked on cars so I was wondering if some of you might chime in and tell me how bad it really is and can it be fixed\. From what I can tell the rust is isolated to the drivers side front. The passenger side and trunk only have minor surface rust but seem to be in good shape. Also the floor boards seem to be in good shape on both sides. I do not have the skills to do this myself and I am very nervous bringing it to someone as I want it done right and not half arse. Take a look at the pics and let me know what you think. By the way, does anyone know of a…
Last reply by Dave WM, -
- 36 followers
- 227 replies
- 43.3k views
This organization posted to the Datsun 240Z Classifieds page on FB yesterday. Does anyone have experience with their products? In addition to the pictured stainless steel 240Z bumpers with rubber strips, they also offer the bumper without rubber (and the holes) per an email exchange I had with them. Looking for some feedback on quality and fit. Thanks, Jim http://bumperautomobile.com/
Last reply by ETI4K, -
- 1 follower
- 3 replies
- 509 views
Wondering what else I check after the fuse?? Fan wires are a bit sticky.
Last reply by Zed Head, -
- 9 followers
- 80 replies
- 37.8k views
Hey, everyone I'll try to make this as short as possible, but there is a lot that has gone on in the past couple of days between me and various people of 123ignition so I will try my best. I will post copies of a pdf file containing the emails between the various employees of this company. I am pointing out now that I have intermediate experience in mechanics and engine building but there is a lot for me to learn still. This isn't really much of discussion on the fundamentals of timing, installation, etc. This is more so a post regarding quality of a product and quality of customer service. I ultimately don't want people to make the same mistake I made. I under…
Last reply by AK260, -
- 3 followers
- 9 replies
- 1.4k views
Hello Recently broke the choke lever handle on my 72. Trying to repair, but it is not going well. I am looking for a replacement. I have attached a photo of a correct handle for 72. contact me if you have one for sale. Thanks Jim
Last reply by DatsunZGuy, -
Coil Question 1 2
by 7tooZ- 1 follower
- 22 replies
- 2.6k views
What are the symptoms of a Bad coil? I am running a Fireball PS30 along with a Crane XR3000 and Crane points replacement.
Last reply by Zed Head, -
- 3 followers
- 10 replies
- 1.4k views
I was tearing into my old seats to take the rails out and fit them to my bucket seat. But then I noticed that the passenger seat rail doesn't slide back all the way. With the car being 50 years old I thought they must have just jammed. But after I lubed them up and slid them back and forth a bit they still refuse to go back to the rearmost notch. At this point I started taking them off the seat and was going to take them apart and figure out what is going on. However, after I spent 20 minutes looking at them I realized that one of the rails may not be intended to slide back all the way! I then searched around the internet for similar informations but didn't see any.…
Last reply by Carl Beck, -
- 5 followers
- 14 replies
- 1.4k views
Hello i am looking for original hose clamps for my 1972 240z...the type with the ROUND HEAD Phillips screw. See photos. I need the 1/4 and 5/16” for the fuel lines and the four clamps for the upper and lower radiator hoses. Thanks Jim
Last reply by mailnome, -
- 7 followers
- 29 replies
- 4.8k views
Anyone know where to get one ? https://www.thezstore.com/page/TZS/PROD/classic22d04/10-2251 the early one not the later 72 and up
Last reply by Zed Head, -
- 4 followers
- 111 replies
- 5.8k views
many things not working, horn, signals, wipers, power antenna, no sound from radio... where do i start? replaced all fuses.. are there relays for these? can i get them easily? fuse box a bit oxidised.. maybe clear it? after market steering wheel.. i assume they would have made sure the horn was working when it got put in..
Last reply by Zed Head,
-
Recently Browsing 0 members
- No registered users viewing this page.
