For Sale
Ads from our classified system. You can reply to for-sale ads in this forum.
1,311 topics in this forum
-
- 1 follower
- 1 reply
- 2.3k views
Very clean, complete re-build from frame up, no rust with rubberized undercoating, sound shield installed on interior Rebuilt engine with low miles, rebuild carbs, 4 row radiator with 0 heating issues in over 100 degree heat, Enkei 15' wheels with new black powder coated interior and polished lip. 4spd transmission rear diff has been replaced to fit a 5spd. motorsports 6 into 1 R and R header coated. Mild cam. All receipts for all work done. Photos speak for themselves. Vin#HLS30161738. https://sfbay.craigslist.org/eby/cto/6143337073.html
Last reply by esmit208, -
-
- 2 followers
- 17 replies
- 4.7k views
Restored inspection light with the open slot on one mounting foot and 12V 8W stamp on the top of the case. Newly replated (yellow zinc) case and switch nut / washer. No dings or scratches on the case. New lens and rubber gasket from 240ZRubberParts, new grommet for wiring port. Switch disassembled, cleaned, lubed with dielectric grease. Includes buyer's choice of replated sheet metal screws (suitable for 240Z fender mount) or hex bolts for other vehicles. $85 includes shipping within CONUS, payment via PayPal.
Last reply by Patcon, -
- 1 follower
- 1 reply
- 1.4k views
Hi guys, Unfortunately I'm selling my 1973 Datsun 240Z. Let me tell you this - I would not sell if I absolutely didn't need the money for personal reasons. I bought the car in Nevada and drove it down to LA. It is a California Registered car. Tags run out end of June. The car is in great condition and has too much power from the Chevy 350 V8. It is a 4 speed manual transmission. Here are the cons: Needs better brakes for stopping the V8 power (current ones work but it could be better for sure) There seems to be some issues with the battery (I replaced it a few times). Seems like something is draining the electricity Needs better tires in the fron…
Last reply by Zed Head, -
- 2 followers
- 1 reply
- 1.5k views
Very clean, complete re-build from frame up, no rust with rubberized undercoating, sound shield installed on interior Rebuilt engine with low miles, rebuild carbs, 4 row radiator with 0 heating issues in over 100 degree heat, Enkei 15' wheels with new black powder coated interior and polished lip. 4spd transmission rear diff has been replaced to fit a 5spd. motorsports 6 into 1 R and R header coated. Mild cam. All receipts for all work done. Photos speak for themselves. Vin#HLS30161738. https://sfbay.craigslist.org/eby/cto/6143337073.html
Last reply by travers, -
- 3 followers
- 7 replies
- 2.1k views
Location: Dallas/Fort Worth I have an L28 turbo motor/trans for sale. Did a full Rebuild on it back in high school (2004-2005) drove it for about 3 months then had a valve issue and parked it. Joined the military after graduation and the car has been sitting ever since. Though about doing a restoration on the car but the body was rusted out beyond repair. Other than that valve issue the motor is in excellent shape. Comes with 5 speed trans, complete wiring harness and ecu. Make an offer!
Last reply by Apoc628, -
- 4 replies
- 1.6k views
For Sale: Z Car Source 280Z/ZX non turbo 5 speed transmission rebuild kit. $180 + Shipping Excedy stock replacement clutch disk and pressure plate $100 + Shipping Clutch master cylinder $10 Clutch slave cylinder $10 Clutch fork $20 Rear main seal $25 Braided stainless clutch line $25 Everything you need for a rebuild of your 280Z/ZX non turbo 5 speed transmission! All prices are OBO. Will make a deal if you take it all. .
Last reply by torynich, -
- 0 replies
- 1.1k views
I have two of these. They normally sell for about $125 + shipping but I had both of them gone through. As you can see, it's in beautiful condition. All of the hardware has been replated, bushing nice and tight. The rebuild cost me $50 each TB so how about $125 + shipping? TPS is spoken for...
Last reply by conedodger, -
- 5 followers
- 57 replies
- 11.6k views
Just thought i would post this on here before i put it on ebay.
Last reply by Gav240z, -
- 1 follower
- 1 reply
- 1.2k views
Just passenger door, no window frame, or panel no reasonable off refused rhchew@att.net 909 560-3095 So Cal LA area
Last reply by esmit208, -
- 0 replies
- 1.8k views
Reconditioned Nikki fuel pump for 240Z. Thoroughly cleaned and lightly polished, new oil seal, new diaphragm, all fittings replated. Valves and diaphragm tested for proper operation. $235 shipped within CONUS. Payment via PayPal.
Last reply by jfa.series1, -
- 0 replies
- 1.1k views
I will be trailering my car up to Austin for the Z convention. I will be bringing several parts with me for those that are interested. Series 1 hatch in good condition with horizontal glass, vents, interior panel cover ( black) and hinges Left Series early 70 door with window, locks/handle mechanisms, exterior door handle, hinges and stainless trim Right Series early 70 door with window, locks/handle mechanisms, exterior door handle, hinges and stainless trim e31 take off head in good condition with intake manifold, cam, lifters, valves, springs, ( no valve cover) I am going to check my parts stash to see if there is anything else for me to br…
Last reply by texis30O, -
- 2 followers
- 3 replies
- 1.7k views
OEM 240z Factory Exhaust System (Mint Condition) This was a near new take off exhaust system and a great setup for someone looking to do a back to factory restoration. I would think it would be very hard to come across another one in this condition. I believe there are two variations of the factory exhaust and this one is the later one used on late 71-73 cars. There are no holes or rust and over all its very clean. There is a small dent on top of the the muffler canister where it would not be visible once mounted. Its very small and insignificant. Price: $1000 plus shipping costs. Located in Los Angeles.
Last reply by oemz,
-
Recently Browsing 0 members
- No registered users viewing this page.
