For Sale
Ads from our classified system. You can reply to for-sale ads in this forum.
1,312 topics in this forum
-
- 2 followers
- 19 replies
- 4.5k views
Pros: Car has been in Murrieta, CA from 1993 unitl 2010; Texas until 2016. Been in TN for one year. 3.1 stroker setup with 1000 miles since build. Z Therapy carbs with needle setup for 3.1 stroker engine. Light wire harness relay upgrade. Z Specialists 125 amp alternator. S2000 seats. Innovate O2 wideband. Cold air intake. 79 280zx 5 speed that was overhauled 2014. Fuel pump inertia cutoff switch. USB wired in glove box. Floor pans are solid. Floor from firewall to rear was primed and then Fatmat installed. Toyota 2 piston calipers with 15/16 master cylinder. Just replaced clutch master cylinder. Cons: Front end is loose. Rod ends were replac…
Last reply by grannyknot, -
-
- 1 follower
- 0 replies
- 1.5k views
1976 Datsun 280z. Red. My mom is the original owner of this car and I've had it for about 10 years. It's been a daily driver in my family since it was bought off of the floor 1976-- very fun drive! The parts are in great condition & original. Even the air conditioning works! No rust! The sound system is shot, the bumpers & upholstery are not in great condition, and there's a small dent in passenger door (pictured). The body's in good condition-- paint could probably use a few touch-ups. Asking for $8500 (obo). Los Angeles pickup. Let me know if you're interested!Pictures: https://flic.kr/s/aHskTqTUU7
Last reply by MissB, -
- 0 replies
- 731 views
i bought these from msa. these are new factory springs and retainers, never used. i paid $150 +/- asking $125 shipped priority mail in the lower 48
Last reply by sweatybetty, -
- 1 follower
- 3 replies
- 959 views
Hey guys got my fuel injection up for sale because im not smart enough for it..lol im located in salem oregon.
Last reply by SteveJ, -
- 1 follower
- 5 replies
- 1.6k views
Rare S30/S130 option factory footrest. Not an aftermarket fitment that some mistake these for, nor a re-production. These are rather useful for your passenger to use, especially to brace against whist the car is being spiritly driven. Your driver, gets to hold the steering wheel! My understanding is this for sale is the S130 option footrest, though I am only really going by seeing this type listed as such on Yahoo Japan. But it could easily be a different type for the S30 range, there are two different part numbers listed on the original S30 parts number book, and also I have seen about 5 versions of S30/S130 option footrest. So, it is not a done deal which mode…
Last reply by Gav240z, -
- 2 followers
- 7 replies
- 2.2k views
A longshot, but never hurts to ask! Please let me know if you have one or both of these items that are half decent at a fair price. Thanks!
Last reply by Gav240z, -
- 3 followers
- 5 replies
- 1.7k views
I have a R200 from an 86 300ZX and all of the parts to bolt into a 240Z. I will entertain offers for next couple days. R200 3.70 Speedo conversion Stub axles Halfshafts Front R200 cross member Rear R200 cross member PM me if interested Don
Last reply by TheErictag, -
- 1 reply
- 2.3k views
For your consideration is a Holley carb conversion package with everything you need to run. Includes 240Z SU type intake manifold, 4 barrel conversion manifold, 1 Holley 390 cfrm in good condition with fresh rebuild, 1 spare Holley 390 carb of unknown condition (may need rebuild), linkage arm, and chrome air cleaner with filter. The 4 barrel conversion manifold is an odd beast for sure. Looks like it was made for a blow through turbo. It really drops the carb down low and has connections on the bottom for some kind of cooling (or heating?) system. Really interesting piece. I took this off a ITS race car we are currently restoring. Going back to SU's. I tried to ta…
Last reply by theblackpearl, -
- 3 replies
- 1k views
If you had bought replacement hatch hinge boots from Nissan years ago, they would have come with these plates that keep the boot from deforming when the hinge is bolted up. The S30 Fairlady fiche correctly shows the boot as an assembly while the online parts catalog does not. The new aftermarket boots available now do not come with these plates and if you're swapping out to new boots, the old plates on your car may be in rough shape. Note that these are not shims (P/N 90407-E4100) of which there may be as many as four on a car. These came off my car (I came by a set of new ones) and are in great shape, newly replated, a correct L/R set. There is no P/N for these item…
Last reply by jfa.series1, -
- 2 followers
- 2 replies
- 1.2k views
https://seattle.craigslist.org/sno/cto/6031282879.html
Last reply by Reptoid Overlords, -
- 0 replies
- 2.5k views
Here's another rescue and refurb item: a complete 240Z glove box door assembly. The logo has been repainted, also the metal hinge plate and right side swing arm have been cleaned and repainted in satin black. The door has a 1" boomerang shape scar on the lower right corner plus a small ding to the left of it. Both are low enough not to be readily visible. The inner panel is in great condition - NO DAMAGE to the hinges. The remnant of the key code sticker is on the panel, its up to a new owner to decide what to do with it. The lock striker is newly replated. All screws and washers are included. It will be shipped knocked down - some assembly required. It may not b…
Last reply by jfa.series1, -
- 1 follower
- 4 replies
- 1.7k views
Swap out your rusty, nasty hatch lock and striker with this freshly replated set. Fits all S30's. $35 includes shipping within CONUS.
Last reply by Patcon,
-
Recently Browsing 0 members
- No registered users viewing this page.
