Old For Sale Ads
Forum that contains old classified archives.
1,797 topics in this forum
-
- 5 replies
- 1.2k views
About fifteen years ago, I purchased several thousand dollars worth of new Nissan parts for a 7/70 240Z I intended to restore. However, the "gentleman" I contracted with to weld in new patch panels didn't use a MIG welder as promised. He therefore totally ruined the car. I eventually had to scrap it. I'm now looking for another 1970 Z (the earlier the better) to restore using all of the NOS parts I still have stored away. Is there one out there for a reasonable price?
Last reply by ZSource, -
-
- 0 replies
- 1.4k views
1972 Datsun 240Z For Sale. 90% Restored This car is very complete and original. Antique White, w/ Burg Interior. Not one rip or tear. Two Hairline cracks over gauges in dash. Non-Stock items include new 5spd Trans, Period Mags, (very tastefull w/spinners) Alpine CD (Door were not cut for speakers) Stock Items include: Recent Clutch and Slave Cylinder U-Joints Struts Shocks Brakes Calipers and Cylinders Tires Radiator All new hoses and Belts in last 6 Months Re-sync carbs, carbs rebuilt exhaust New rear diff gaskets and seals The list goes on and on…. This car needs a home for someone who can care for it. Will only sell to owner w/ garage for it. …It deserves t…
Last reply by roster, -
- 0 replies
- 679 views
I have A pair of T-Tops for A 280zx. Like new dark tint good rubber & scratch free. I have never owned A zx or plan on one. The price is open offers\Trade. I would like for them to go away. Some one left them with A girlfriend who was working @ A gas station. The guy said he didnt have the money for the gas he pumped poped out the tops on his ZX and asked her too hold them till he came back to pay for his gas. Three weeks later she called and asked if I wanted them. Please someone must need A set. (I know theres one ZX out there that needs tops. )
Last reply by carguyinok, -
- 6 replies
- 1.1k views
I have a couple rb20det front clips that I have to sell soon. This has become a more popular swap lately for most z car owners. It is still a straight 6 motor so the dimensions are roughly the same. The bonus is it is a factory turbo engine and uses coilpacks. These are the whole front cut of the skyline for sale so you will get the larget radiator and all the pipes and hoses. I have wiring diagrams if you need them. The rb20det also comes with ~205hp stock and can easy be upgraded by increasing the boost and tuning the engine control module. I am asking $1400 plus shipping for each clip. Shipping is usually around $400 depending on location. Email us at sales@acclerated…
Last reply by j240sxna, -
- 2 replies
- 1.1k views
i'm selling my '73 240. everything works on it very well. i've put in a holley 4-barrel carburetor, brand new. it's also got new tires. the thing is that the bottom is pretty rusted on the front half, including the frame. it's pretty bad, but i was wondering how much could i possibly expect to get out of a car like this in the u.s. any general guesses would be extremely helpful. thanks!
Last reply by chocobosteve, -
- 3 replies
- 1k views
all the items came off a stock 73 240z - free front stock sway bar, no mounts. -free fan with clutch, one pieced together to fit a 240z radiator spacing from 280z clutch and 300zx fan, other fan off a volvo, does not fit L-series waterpump -free set of 4 stock datsun springs. I think they're rated around 110 lbs/in? -pair of front stock sumitomo 240z calipers. pads seem to be ok, calipers worked when they came off the car. also a pair of front stock Z rotors. doesn't look like they've been turned, just covered in thin surface rust, but worked fine when removed. make me an offer for the combo -r180 rear diff with r180 mustache bar - no halfshafts. was removed from a ru…
Last reply by owenk, -
- 8 replies
- 1k views
For a 240Z 1972. Thanks.
Last reply by guy_geo, -
- 0 replies
- 759 views
anyone know where i can get a pre-#500 1970 z? i live in cali... the closer the better. thanks
Last reply by glizzen, -
- 3 replies
- 1.2k views
All original no Mods early 71' 240Z Arizona car located in Florida 118,000 miles ORANGE W/BLACK INT $3,500 Gas tank redone by gastank renu. surface rust on floors and battery compartment used por-15 to cover and bought new carpet kit. Most rubber seals replaced. Car had rust proofing at one point. I am 3rd owner. small patches on side and hatch done by 2nd owner surfwave@hotmail.com
Last reply by ShredZ, -
- 0 replies
- 883 views
Father's 1971 240Z, purchased new, first one in WA state, registered to the family business. Vehicle burned to the ground in the process of being rebuilt in a shop fire. All the manuals were in the glove box at the time of the fire and survived very well. No rips, tears or pages missing. Have very, very, little smoke damage on the bottom edge of the books. Included in set, Owners Manual, issue date of July 20th, 1970, Warranty and Service Booklet, including the Warranty Card, used to 24,000 miles but only the 600, 3K, 6K, 9K, 12K and delivery inspection pages torn out, issue date of July 10th, 1970, Consumer Information Booklet, issue date of September 10th, 1970, Datsun …
Last reply by spedrcr, -
- 6 replies
- 1.2k views
ok, now here we go. gas tank dirty as hell dent and rust free with good sending unit. vapor tank like new. seat belts(working fine good springs) and no tears or fade there just dusty. and I have all the parts just put A few out for the pics. I live in north east Oklahoma and ship u.p.s at work every day. you pay shiping.....
Last reply by EScanlon, -
- 2 replies
- 1.1k views
Location: California Bay Area just got a 260Z and am doing an engine swap so i don't need it anymore. It's in fair condition. 260,125 miles. $250. If anyone wants pics, let me know and i'll learn how to post them:stupid: other things include: (can talk about prices) front and rear bumpers (need a little polishing) manual transmission (???) tail lights (right rear is cracked) front (planar) turnsignals (good condition) if anyone wants/needs anything else, i'll be willing to give or sell it to you if i'm not going to be using it. rob
Last reply by hayai-z,
-
Recently Browsing 0 members
- No registered users viewing this page.
Parman
