Interior
Discussions about the interior components of your early Zcar.
2,366 topics in this forum
-
- 5 followers
- 6 replies
- 4.1k views
Last reply by SteveJ, -
-
seat spacers 1 2
by zhead240- 1 follower
- 12 replies
- 3.5k views
are these the seat spacers? when I removed the seats one spacer was on top of the seat bracket, the other was screwed under the nut and washer. can I put both spacers above the seat bracket to raise the seat? is that what it's for?
Last reply by Patcon, -
- 4 followers
- 13 replies
- 4.8k views
I am reconnecting my existing aftermarket (brand?) to an upgraded audio system. All hookups were disconnected over a yr. ago and I have no installation guide to refer back to. I am trying to remember which antenna toggle switch wires connect to factory blue, blue/red stripe and blue/white stripe wires. The toggle switch has six connection spades and three different color wires: red, green & black(antenna already grounded to body, near antenna so just leave black wire disconnected or make another body ground under console?) . **I will attempt attachment photos of toggle switch which is worth many,many words description.**. As simply described as 2-reds an…
Last reply by Packerz, -
- 3 followers
- 2 replies
- 987 views
I was completely shocked by an ebay seller lately that was selling the black plastic insert (called by Nissan as an escutcheon) behind the door handle. This seller was asking $130 for 1 right and $130 for 1 left. The part number was shown in the ad, so I went to NissanPartsDeal.com and searched for the part number. The site showed that it was available for $5.58 each for either right or left. Apparently, this part was being made again. Also MSA was selling for more reasonable $8.18. Also, I found the window crank available for $28.97 each plus shipping which MSA was selling at a reasonable $38.87 I wonder where we can find more parts number to sear…
Last reply by Mike, -
- 1 follower
- 0 replies
- 978 views
Does any one know which type and size is the screw that goes accross the steering cover shroud and fastens here in the turn signal switch? My car is a 72.
Last reply by jalexquijano, -
- 1 follower
- 4 replies
- 791 views
Random question but what is the point of the rectangular hole in the back of the center console. I am putting in a new center console and never really figured it out. Sent from my iPhone using Tapatalk
Last reply by AZDatsun, -
- 4 followers
- 5 replies
- 3.1k views
My driver's side door lock has been difficult to unlock since I acquired the car. The little arm attached to the lock cylinder that fits inside the locking mechanism in the door has way too much play and I had to jiggle the key back/forth forcefully to get it to unlock. While I had the door glass out, I cut a small piece of fuel line from an old weed-eater and slid it over the arm. It works so much better now. Easy to lock/unlock with very little force needed. I shot a little silicone lube on the outside of the hose to keep it from binding in there. Is good, yes?
Last reply by Hardway, -
- 1 follower
- 3 replies
- 932 views
What is the easiest way to remove these from the center console. I have 78 280z and want to take them all out to clean them and service them. I seems like they are stuck in there pretty good and I don’t want to break any plastic. I am referring to the row that contains the hazard switch/rear defroster Sent from my iPhone using Tapatalk
Last reply by heyitsrama, -
- 1 follower
- 0 replies
- 1.1k views
Just installed the pair of Msa 3 point retractable seatbelts in my 1972 240z. There are okay and rub a little bit on the neck. I will keep the original ones as i would like to restore them. I did opened a hole in the carpet and jute as the gear look better over the carpet. Any recommendations?
Last reply by jalexquijano, -
- 2 followers
- 7 replies
- 972 views
Yesterday the window of my driver door in my 240z got shifted due to slamming the door to hard. I had to remove the window crank and panel and discovered that some bolts were missing. The original window regulator works fine but some bolts should be replaced. Are they available? Who sells the hardware?
Last reply by jalexquijano, -
- 8 followers
- 31 replies
- 7.8k views
after reading a few posts on this (most recently the great write-up by hardway) i decided to go for it. my fan has been making some pretty horrible noises - whining, screeching etc. and the output was weak. picked up a honda fan assembly for $30 on fleabay, gave it a quick clean and got myself geared up for the job. i won't go into all the details, as this has been posted before, but i will whole-heartedly validate the improvement. the new fan is quiet and blows like crazy. couldn't believe how much more efficient it is at moving air. the design is basically the same, but the honda fan has a lot more vanes, which are smaller and it's a slightly larger diameter - about …
Last reply by jalexquijano, -
- 1 follower
- 18 replies
- 4.2k views
I was looking at the pics for 240Z #476 that is on e-bay right now, and came across the attached pic of the passenger interior. Two questions: What is that big box under the dash? Something for air conditioning, like the evaporator maybe? And second, there seems to be a vinyl covering over wiring just at the end of the console - you can see three snaps on it in the picture. Is this something standard? My car doesn't have either the under-dash box or the vinyl cover. I may have to look for one of the vinyl covers if it is normally there... Thanks.
Last reply by zspert,
-
Recently Browsing 0 members
- No registered users viewing this page.
KenFirch
