Old Want Ads
Old ads for wanted items.
880 topics in this forum
-
- 0 replies
- 778 views
In good running shape for daily use probably. I'm in MA. I can be reached at mbowers01@comcast.net Thanks! Mike
Last reply by mb27, -
-
- 8 replies
- 885 views
tried to put on my 14 inch spare the other day and it doesnt fit becouse of my brake/suspension mods. im chasing a wheel 16 inches or bigger with standard datto stud pattern. also has anyone got a decent blinker switch they want to sell? im about to go through rego and i cant turn left...
Last reply by Gav240z, -
- 0 replies
- 831 views
Looking for mechanical tach drive L24 distributor for vintage race car project.
Last reply by rzola, -
- 2 replies
- 944 views
I am in need of some oversized piston pins. I have a set of oversized pistons but the pins look to have been beat out with a hammer. I can have the pin holes honed out but then the piston pin is too small. Has anyone out there run into a similiar problem? Any help? Thanks
Last reply by Ed, -
- 9 replies
- 1.4k views
I want either a datsun 240z or 260z, if n e 1 has 1 for sale plz notify me, thanks!
Last reply by Fun_in_my_z, -
- 6 replies
- 1.1k views
I need some parts from a '70 or early '71 series 1!! The center console (if in very good shape with no cracks, breaks, etc) Got It! Heater/Radio panel (no controls, just the plastic cover panel)(if in very good shape with no cracks, breaks, etc) The ashtray The valve cover (if it is the same as mine, reads "NISSAN 2400 OHC") Got It! Fuse box and cover (if in very good shape with no melts and has long pigtail) Got It! Hand throttle (I know that I may never find one) Combo switch (the one that has the lights, wipers, and turn signals on it) JDM tail lights Got It! SS braided brake lines Got It! [/list=1] Please provide prices, pix, and any other info you have on the…
Last reply by Z 4 Z, -
- 18 replies
- 1.4k views
I am looking for an LD28 crank to build a stroker motor with. Does anyone out there have one, or know of one for sale?
Last reply by Gav240z, -
- 21 replies
- 1.9k views
Just as the header states. I'm in need of Euro tail lights for my 72 240Z and an R200 LSD with 3.7:1 ratio. Please e-mail privately. I know these items can be hard to get and I will pay a fair price. Tyson turbobuick87@hotmail.com
Last reply by Mr Camouflage, -
Rear lights 1 2 3
by Sean Dezart- 25 replies
- 2.3k views
I have a US spec car and I want to change the rear lights for the European look ie orange indicators (turn signals) Anyone got any (very good) ones spare ? Should also ask about Hella H4s as well ?
Last reply by Mr Camouflage, -
- 0 replies
- 822 views
I need for a hood for a 77 280z. If anyone has any info please leave message
Last reply by jmac4010, -
- 3 replies
- 953 views
Urethane or fiberglass, I don't care. I will make offer if someone has one!
Last reply by Mike, -
- 1 reply
- 793 views
i'm living in Indiana i want a "Fair Lady" so bad -clean body with no rust or little enough to be fixed easily -runs (minor work or major work needed is fine) -don't care about the interior thinking less than 1000 hacker666@lycos.co.kr this is my email. if you have a sleeping beauty, gimme a message!
Last reply by mdbrandy,
-
Recently Browsing 0 members
- No registered users viewing this page.