Technical Articles
Technical articles and how-to articles
Subforums
-
- 466
- posts
-
- 178
- posts
164 topics in this forum
-
- 1 follower
- 0 replies
- 1.4k views
You can view the page at http://www.classiczcars.com/forums/content.php?142-Rating-the-factory-240Z-fuel-vent-hoses&
Last reply by Arne, -
-
- 0 replies
- 1.2k views
You can view the page at http://www.classiczcars.com/forums/content.php?129-Rearview-Mirror-Restoratiom
Last reply by hls30.com, -
- 0 replies
- 1.1k views
You can view the page at
Last reply by EScanlon, -
- 0 replies
- 1.2k views
You can view the page at http://www.classiczcars.com/forums/content.php?160-1971-240z-License-Plate-Lamp-Photos
Last reply by 240260280z, -
- 0 replies
- 1.1k views
You can view the page at http://www.classiczcars.com/forums/content.php?157-Hatch-Vent-Trim-Installation
Last reply by 240260280z, -
- 0 replies
- 1.1k views
You can view the page at http://www.classiczcars.com/forums/content.php?151-Brake-caliper-restoration
Last reply by Eric_Shea, -
- 0 replies
- 976 views
You can view the page at http://www.classiczcars.com/forums/content.php?158-Refreshing-Hatch-Vent-on-early-240z
Last reply by 240260280z, -
- 10 replies
- 9k views
I just refreshed a transmission and took pics as I disassembled and reassembled. There aren't many pics on the net so this will hopefully help others. Parts: 3 Gaskets, 2 front bearing shims, 1 front bearing clip, 18 M8 X 1.25mm bolts, drain/fill plugs, speedo gear w locking clip and bolt. Not included: throwout bearing, throwout collar, fork, spring clips, slave cylinder (will be added to post later) Rear most housing with the famous "monkey motion" assembly. Inside the rear housing. You can see the striker rod that is driven by the money parts. It was bent and slightly deformed in this old transmission making removal of the rod and the rear part of the housin…
Last reply by 240260280z, -
- 3 replies
- 2.9k views
You can get most of these at "dollar stores", hardware stores, kitchen stores, Ikea, and Walmart-like places CANISTERS Use these stainless steel canisters with lids to soak your parts. The lid keeps the fumes contained and allows you to slosh the can around with parts inside. The lid also keeps pets out and minimizes evaporation. Since they are stainless steel you can leave them outside to keep the fumes out of your garage/house and they won't rust (too much ). The typical use is for holding dry stuffs such as sugar, flour, and cookies. Be sure to consume these before robbing your wife's kitchen. Also, it is wise to buy 2 or more and in various sizes.…
Last reply by 240260280z, -
- 1 reply
- 2.1k views
Last reply by FastWoman, -
- 4 replies
- 3.2k views
Last reply by 240260280z, -
- 0 replies
- 3.4k views
Last reply by 240260280z,
-
Recently Browsing 0 members
- No registered users viewing this page.
