Open Discussions
Open discussions about the early S30 series issues and topics.
8,795 topics in this forum
-
- 1 follower
- 3 replies
- 2.2k views
Have this been posted before https://www.panchkits.com/kit-cars
Last reply by Patcon, -
-
- 5 followers
- 15 replies
- 1.8k views
In the process of rebuilding my 77 280z. Pulled the tank and cleaned out the rust. I am not going to be reinstalling it until at least next year so I would like to know if anyone has any suggestions as to how to store so that it won't rust again.
Last reply by heyitsrama, -
- 5 followers
- 13 replies
- 1.5k views
https://bringatrailer.com/listing/1967-toyota-2000gt/ I'm aware of these cars, the story behind Yamaha, what they are and so on. Don't get me wrong, I really like them. But if they were worth the same money as a 240z and two cars were sitting side by side, I think the Z has more visual appeal. That is of course assuming the Z isn't wearing its factory hubcaps.
Last reply by calvinhg, -
- 5 followers
- 11 replies
- 1.4k views
Not mine, nor affiliated. Strictly for the benefit of the group! -Car number 795 has a little rust but runs and drives https://losangeles.craigslist.org/lac/cto/d/1970-datsun-240z-series-1-low/6714000848.html
Last reply by grannyknot, -
- 15 followers
- 119 replies
- 11.2k views
Hello everyone, I'm a noob and have been patiently searching for the right Z. I have an opportunity on a 2 owner 78 280 w/100k still has the original dealer LIC frame and MSRP with tons of records, Very freaking clean but have no idea what the actual value is.... HELP [emoji23] Sent from my XT1650 using Tapatalk
Last reply by riverstonefly, -
- 1 follower
- 3 replies
- 687 views
How does the HVAC fan knob come off? I found the small screws to remove the sliding lever knobs, but can't figure out how that fan control knob comes off. Anybody know how to remove it?
Last reply by Sunline, -
- 6 followers
- 12 replies
- 2.8k views
I have been "lurking" on here for almost a year, after doing research for a header/exhaust on this forum I ran across a post that said there was a discount code for MSA. After following the directions given I placed my order and yes there is a discount (approx. 10%). I have ordered parts in the past from MSA but didn't know or ask for a discount, shame on me. Better late than never. On a side note, if any Vendors read this put in your Bio that there are club discounts, you may gain more business that way. Thanks Again CZCC, Mike
Last reply by Mark Maras, -
- 3 followers
- 7 replies
- 889 views
I have a very nice set of headlight lenses but they have a lot of small scratches. Does anyone have any expierence with polishing these guys?
Last reply by Jaymanbikes, -
- 2 followers
- 1 reply
- 995 views
Are there any differences between 70-73 SU carb linkage? Specifically the center linkages and the linkage from center to throttle? Thanks.
Last reply by Zup, -
- 3 followers
- 13 replies
- 3.2k views
After I noticed a comment on the WHP site about their 70-72 front bumper brackets about needing to heavily modify them to fit a 73 (https://whiteheadperformance.com/product/new-datsun-240z-260z-280z-stainless-steel-euro-bumpers/), I did a bunch of searches of this and other sites and haven’t been able to confirm that this is or isn’t true. I did find someone on ZCar.com saying that you have to do a bunch of work to make them fit, but in that same thread someone mentioned that the original 70-72 mounting points are still there and that the 73 bumper brackets mount in a different location (https://www.zcar.com/forum/10-70-83-tech-discussion-forum/321961-73-bumper-brackets.h…
Last reply by Matthew Abate, -
- 1 follower
- 1 reply
- 969 views
having trouble putting fuel tank back under the car fuel neck is to stiff wont budge after we line it up is there a way to soften the neck please send ideas to chaybedian@gmail.com thanks from pa
Last reply by jfa.series1, -
- 2 followers
- 1 reply
- 2.5k views
What are the differences between standard Mikuni and Nismo Mikuni carburetors?
Last reply by duffymahoney,
-
Recently Browsing 0 members
- No registered users viewing this page.
zKars
