Open Discussions
Open discussions about the early S30 series issues and topics.
8,795 topics in this forum
-
- 0 replies
- 570 views
https://www.carbuilder.com/uk Their inventory is so extensive that I think it might be worth the extra shipping.
Last reply by grannyknot, -
-
R200
by ennisdavis- 2 followers
- 3 replies
- 603 views
Did all 75' S30s with manual trans come with the R200?
Last reply by Zed Head, -
- 2 followers
- 4 replies
- 686 views
Do the door sills sit flush on the rockers or is there a slight gap where i can weld patches on the rocker?
Last reply by dutchzcarguy, -
- 3 followers
- 6 replies
- 1.2k views
Hello i am just back from the AACA Eastern Fall Meet at Hershey, PA. I entered my Z in the Historical Preservation Original Features class. In that class you are judged against a standard of originality. Anything restored or incorrect aftermarket gets a deduction. Used, NOS and OEM replacement parts are allowed. Owners are asked to disclose anything they know has been restored or modified. You are allowed up to seven deductions. Under that and you qualify for a HPOF award. My car is pretty much original but has had two minor body repairs/paint and the fuel line in not totally correct (correct routing but a new piece near the filter has been replaced using a Unio…
Last reply by VaCat33, -
- 3 followers
- 10 replies
- 1.3k views
Found these in the oil strainer. Magnified one and its the shape of an isosceles trapezoid. Size of a tooth pick tip. Magnetic. Its not shrapnel because it has a formed shape.
Last reply by Ninjaneer11, -
- 3 followers
- 14 replies
- 1.1k views
Hello fellow Houston Texas area Z owners. I have cleared out my storage unit and I will be liquidating some of my excess Z and roadster parts. Keeping what I deem critical. I have a recently rebuilt type B 4 speed with about 2000 miles on it. I have a 1971 Z orange airbox I have a polished manifold for SU's I have a like new Cannon manifold for some Webers that I ran for a while and looks good. Have a 1971 Z radiator in good shape as well. Have many sets of spark plug wires and other odds and ins as well. I have a couple of distributers and ballast resisters. If any Houston area Z owners are in need of anything, Mos…
Last reply by Wally, -
- 3 followers
- 5 replies
- 902 views
Pulled the dash to install LED's and upgrade harnesses.. and clean ha... per the usual I have an extra piece that I did not track on the take down. does anyone know this piece??
Last reply by nolan schwartz, -
- 6 followers
- 55 replies
- 8.2k views
I sure hope VP Pence gets this Corona virus under control before ZCON.
Last reply by zspert, -
- 1 follower
- 6 replies
- 753 views
I have noticed a difference between the 75 and 77 ecu's. Same part number but different. The 77 is missing pins and has 2 fins that stick out from the center of the connector
Last reply by AZDatsun, -
- 1 follower
- 4 replies
- 731 views
Here are two valances, one is recognizable, the other is not. The brackets on the short one are definitely Datsun, but too short for 240z.
Last reply by zKars, -
- 2 followers
- 4 replies
- 1k views
Anyone make the plenum air inlet or is it custom time.
Last reply by texasz, -
- 4 followers
- 6 replies
- 893 views
Last reply by Mike,
-
Recently Browsing 0 members
- No registered users viewing this page.
