2nd & 3rd Generation - S130/Z30/Z31

I do not owned a zx nor do i want one but..... I know most of you have probably already seen this.

Hello everyone. I am new to the forum and was hoping that someone could give me some advice about a transmission for a 1980 280zx. I pulled the transmission to replace the throwout bearing and clutch, and when I drained gear oil, bearing pieces were in it. I feel that the tranny needs to be rebuilt, but am unsure how to proceed. Should I have someone rebuild, or should I look to purchase a rebuilt transmission? I have never done myself, and am a little nervous to rebuild on my own. Does anyone know of a good z-car transmission rebuild shop in the Washington DC, Baltimore area? What about the big tranny rebuild places you see advertised on the internet? Any advice …

Hi all, i'm hoping i can get some assistance. If anyone out there knows the Rock hill, SC. / Charlotte, NC general area. I'm looking for Z-Shop specialist. "i'm looking to via pass the ignition module/electrical system to start with. Looking to re-store my 80 280zx. Thank you all, Omi

I have a 1983 280zx with automatic transmission non-turbo engine and it has no computer in it Does anyone know the part number of the ECU and where i could get one thanks

Got my Rewinds today and they just touch the brake caliper which prevents them from seating. I measured and measured and it looks like I will have to grind about a tenth of an inch off of the outside of the caliper just where it touches the rim. The larger brake caliper will have to be ground at the point of the raised "rib" just a bit. I called MSA and they confirm that this is appropriate. Anyone else have this experience?

my 1980 280zx is dead. i put a new battery in it and it wouldnt start after running it for three days, so i knew that the alternator was bad. i went to get a new battery and also some new battery wires and terminals since mine were going bad anyway. when i installed the battery wires and hooked up all the grounds my car was still dead. no lights no nothing, complete loss of power. i have a new alternator and i have tried to find any bad fuses but im not sure what to look for, any suggestions?? thanks

Can anyone tell me where I can find some new or solid used frame rails for my 82 280zx? I really really need some BAD!