Jump to content
Email-only Log-Ins Coming in December ×

IGNORED

my last 6 months


grnskyline

Recommended Posts

ay guys

Anyone want to know what I been doin the last 6 months? Well I pulled out my blown 260 motor and have now dropped in a 280 (stock). Lots of running around but its finnally in! yeay!

Guess what? She dont want to start. The motor wount crank fast enough it seems. Battery is good as I pulled it out of a running regular driving car.

So I thought starter's drawin too much current. Pulled out the old starter and put in another one from wreckers, . ... And ... same problem. It just dont turn.

After a couple of rotations it wount turn at all. Symtoms of a flat battery right! So I got another battery and ......same prob. Last resort is to jump it, havent tried yet

any ideas?

cam\

post-3236-1415079353278_thumb.jpg

Link to comment
Share on other sites

hey

that was fast

k

Engine was bought from wreckers with 3 month warranty. (exp now). I am trusting the source as I have been back many times andhe has been helpful. So I dont believe motor is seized, a dud,etc.

I am using the 260 distributor and have moved it from full advance to in the middle in hope of starting it. I havent tested the lights yet but fuel pump and gages go crazy when ignition on, so there is power enough......

what do do about a dodgy earth?

thanks again

Link to comment
Share on other sites

I agree with Zkid earthing sounds the problem, where does your neg terminal connect to on this new motor and is there now paint or rust stopping a good ground. I would also be running a second cable from the block to the firewall or strut tops.

Steve

Link to comment
Share on other sites

  • 2 weeks later...

ay guys

after alot of fidling and one of the fattest earth wires around she starts!! very exciting!

Only running the extractors at the moment so bloodly loud!!!, sounds like a beast!

however not all joy... she doesnt want to rev any higher than 2ooo revs, missing pretty bad. It looses almost all revs at 2 and power with a bang/misfire and returns to ildle almost. She idles all right, little rough but dont want to rev.

It has an electornic distributor (came from broken 260 motor)havent played with timing much yet but is pretty much set in the middle.

any ideas? plugs? cap?

cam

Link to comment
Share on other sites

carbs :).

Check float levels, richness, lean condition. Vacumm leaks, hmmm check the plugs see if they have fouled up at all.

Hmmm could be distributor but very hard to tell from explanation. Once you had set your carbs correct. Then we will worry about that the distributor.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...

Important Information

By using this site, you agree to our Privacy Policy and Guidelines. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.