has any one personally replaced the frame rails and floor board on a Z, would like to get information from you.

Send Beandip a PM and he can help you out.

Enrique

I've played with my share and would be happy to answer any questions.

Break out the questions.:classic:

im getting ready to change the floors in mine as well.

I'll add:

take note of where the fuel lines are placed BEFORE using the plasma cutter. Damn near lost a 260 the hard wayROFL

My 240 was simple cut, fit, and weld in the new floors. The late 260 had fuel lines run down through the channel beneath the floor. Neat surprise, to say the least.

Found it best to have plasma cutter in one hand, water hose in the other!!