SuperDave Posted February 7, 2005 Share #1 Posted February 7, 2005 I got sloppy while disassembling an L24 block. I didn't keep track of which main bearing cap went where. Oops!It's easy enough to figure out which one is the front, rear, and middle. The rest I'm not sure about. One has a 6 stamped on it, another a 5, and two more don't have anything stamped where the 6 and 5 are stamped. Any suggestions on how to proceed and get this straighted out? Link to comment Share on other sites More sharing options...
240ZX Posted February 7, 2005 Share #2 Posted February 7, 2005 Stick to software Dave! :stupid: Just kiddy with you. You might consider calling a reputable L6 engine builder and see what they have to say about it. Link to comment Share on other sites More sharing options...
beandip Posted February 8, 2005 Share #3 Posted February 8, 2005 send a PM to phred he is a Z engine builder . Gary Link to comment Share on other sites More sharing options...
LanceM Posted February 8, 2005 Share #4 Posted February 8, 2005 If you can not determain where they came from you will have to have the block/caps line bored. If you put it together in any order you are asking for major bottom end failure. Link to comment Share on other sites More sharing options...
SuperDave Posted February 8, 2005 Author Share #5 Posted February 8, 2005 The block is at the machine shop now for hot-tanking. They know Datsun L's pretty well, so I'll see what they say when I pick it up. Link to comment Share on other sites More sharing options...
Patcon
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now