Fun_in_my_z Posted August 15, 2005 Share #1 Posted August 15, 2005 I need door hinges for my 72 Z. I looked at msa and Vb but they dont seem to have any. Unless i missed em. :stupid: Kinda sucks when you put a new door on and it falls off! Link to comment Share on other sites More sharing options...
Fun_in_my_z Posted August 16, 2005 Author Share #2 Posted August 16, 2005 Anybody?....man i looked through this site and at msa and vb. I want them new if i can get em.... Link to comment Share on other sites More sharing options...
seerex Posted August 16, 2005 Share #3 Posted August 16, 2005 I think you might want to try some of the used parts places that are specific to z cars Link to comment Share on other sites More sharing options...
nwcubsman Posted August 16, 2005 Share #4 Posted August 16, 2005 Give Danny's Datsuns a try. Just be sure to tell him to find you nice ones. I bought some water tubes from him and got some junk. He stands behind his parts and replaced them, but it was a hassle. But the replacement was very nice!Danny's 541-430-1180Good luck! Link to comment Share on other sites More sharing options...
Fun_in_my_z Posted August 16, 2005 Author Share #5 Posted August 16, 2005 Thanks bryon ill give him a call.What are the chances of rebuilding them? Link to comment Share on other sites More sharing options...
dspillman Posted August 16, 2005 Share #6 Posted August 16, 2005 HI,Give me a buzz at volgolf@aol.com.I have a couple of sets.David Spillman Link to comment Share on other sites More sharing options...
Fun_in_my_z Posted August 16, 2005 Author Share #7 Posted August 16, 2005 How much are you asking for em? Link to comment Share on other sites More sharing options...
BadDog Posted August 16, 2005 Share #8 Posted August 16, 2005 I bought a used one from Charlie Osborne (Zed Findings of Ontario, Canada) for my '73. I didn't notice 1) it was different from my original hinge and 2) the holes needed to be re-tapped but it worked anyway and wasn't too expensive. I went ahead and used because I had already re-painted it and my door jambs and wanted to hurry up and get my car back together to shoot th epaint on the body.... Link to comment Share on other sites More sharing options...
240ZX Posted August 16, 2005 Share #9 Posted August 16, 2005 Bill,You can rebuild them. Its a matter of replacing the pivot pins. Drill rod is a suitable material for pin replacement. Also, he recommends going to a slightly larger diameter than the stock pins, for obvious reasons. Drill rod is available in many diameteres. Link to comment Share on other sites More sharing options...
agemeansnothing Posted August 16, 2005 Share #10 Posted August 16, 2005 Hey this is out of the blue Iv'e been finding pretty good parts on ebay. I look at ebay first before anything else Link to comment Share on other sites More sharing options...
jmanz6 Posted August 16, 2005 Share #11 Posted August 16, 2005 I bought a brand new, still in the Nissan bags set for my 240 on ebay a while back. I am waiting til I get into the body to install them though. They are hard to find new, but call your Nissan dealer, they may have a way to get them. Check out courtesy nissan as well, I think I remember seeing some there. Link to comment Share on other sites More sharing options...
Parman
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now