I need door hinges for my 72 Z. I looked at msa and Vb but they dont seem to have any. Unless i missed em. :stupid:

Kinda sucks when you put a new door on and it falls off!

Anybody?....man i looked through this site and at msa and vb. I want them new if i can get em....

I think you might want to try some of the used parts places that are specific to z cars

Give Danny's Datsuns a try. Just be sure to tell him to find you nice ones. I bought some water tubes from him and got some junk. He stands behind his parts and replaced them, but it was a hassle. But the replacement was very nice!

Danny's

541-430-1180

Good luck!

Thanks bryon ill give him a call.

What are the chances of rebuilding them?

HI,

Give me a buzz at volgolf@aol.com.

I have a couple of sets.

David Spillman

How much are you asking for em?

I bought a used one from Charlie Osborne (Zed Findings of Ontario, Canada) for my '73. I didn't notice 1) it was different from my original hinge and 2) the holes needed to be re-tapped but it worked anyway and wasn't too expensive. I went ahead and used because I had already re-painted it and my door jambs and wanted to hurry up and get my car back together to shoot th epaint on the body....

Bill,

You can rebuild them. Its a matter of replacing the pivot pins. Drill rod is a suitable material for pin replacement. Also, he recommends going to a slightly larger diameter than the stock pins, for obvious reasons. Drill rod is available in many diameteres.

Hey this is out of the blue Iv'e been finding pretty good parts on ebay. I look at ebay first before anything else

I bought a brand new, still in the Nissan bags set for my 240 on ebay a while back. I am waiting til I get into the body to install them though. They are hard to find new, but call your Nissan dealer, they may have a way to get them. Check out courtesy nissan as well, I think I remember seeing some there.