Reverse lamp wires

[78 280zcar]

Does anyone know which wires on the chassis (where the tranny hooks up to) is the wires for the reverse lamp switch. Thanks

[webdawg1]

Should be two (2) green wires, both female connections. Wires on the switch should both be male unless PO has been cutting away at the wiring for some reason...

webdawg1

[jackboxxx]

on the 240 its a small 2 wire harness that comes out of the main engine compartment harness about 6 inches after it comes through the firewall below the battery area down by the frame rails. (see pic) the wires on my car are red/black & red. there are a couple of retainer/bendable clips to hold the harness next to the frame rail away from harm. the wires have the male/female bullet plugs on them to plug into the wires coming off the rev. switch on the pass. side of the tranny near the speedo cable area.

Pic of Harness under battery tray pass. side near firewall.

[78 280zcar]

Yeah on mine there is six wires down there for the automatic tranny inhibitor switch. I will look tomorrow when I get over there for the green wires thanks guys. Shane