Jump to content
Email-only Log-Ins Coming in December ×

IGNORED

FUSE problems post vandalism


jszarecki

Recommended Posts

I would start with the wiring that was connected to the stereo and make sure none of what is left is shorting, perhaps one of the stereo leads attached to the dash lights for dimming control of the stereo panel lamps and now it is shorted to ground.

Link to comment
Share on other sites

ok, sorry , youre right

However new problem developed this evening on the way home from work.

i turned my brioghts on, and the car started to buck and lose power. a wierd smell was in teh cabin and car started acting very much like a buckig bronco. upon reaching my house, i discoverd the the battery has come loose from teh tie downs. wierd. i think what happened is this. the positive terminal , which is abotu 1/2" from teh chassi/hood (metal) started arcing. woudl this cause the alternator/electrical system to fail? is that what was happeinging. i since cut all ext. wiers from teh positive lead from the battery. hopefully this will solve the problem...

Link to comment
Share on other sites

I'd recommend you get your hands on the correct wiring diagram for your model of zed, then trace out the power feeds for all the gauges. Definitely check for any loose wires coming from the two loom plugs behind the centre console. The ign feed to the stereo is sure to have come from there (and if it didn't, someone wired it up the hard way).

Link to comment
Share on other sites

well yes, than what the hell are all the smaller wires coming off the neg and positive on the car batery. they are attatched to random stuff in teh eng. compartment. also note, i looked under the passenger dash and there are probably 50 wires that are either cut or go nowhere (GNDN). these have alwasy been this way, even when teh lights etc were workign properly. so what are they. i DO have the Chiltons guide for my car, so i havea schematic for othe elec systems. do i just see what colors they are or try and figure out thru all that electricla tape where they come from..

someone else suggested i put in a NEW wireing harness, with an updatee modern fuse panel (the NON tube kind) that sounds liek a nightmare

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...

Important Information

By using this site, you agree to our Privacy Policy and Guidelines. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.