I know this is a dumb question, some people probably say weatherstripping is a fairly self explanatory process. But I just want to make sure I'm doing things right. Does anyone know or have any tutorials on replacing each/most of the weatherstripping on a 240Z?

I don't but I just did all of mine. What is your question ? Gary :classic:

ooh yay! =D

a) How do I take off the rear hatch glass?

How do the Door Cap seals go on?

c)The aftermarket lower door seal from Precision seems to have holes in it. I was guessing it was for screwing it on, but the factory seal that's still on the door doesn't have screws. How should I put this one on?

Thanks for your time, Gary.

There are plastic clips that go through the holes in the w/s, and into corresponding holes in the bottom of the door. you may need to look more carefully to see them, but they are there.

I strongly advise that you buy the book How to restore your Datsun Z-car by Wick Humble it is a Fisher Book . All this is covered and shown in the book . Gary

ooh yay! =D

a) How do I take off the rear hatch glass?

How do the Door Cap seals go on?

c)The aftermarket lower door seal from Precision seems to have holes in it. I was guessing it was for screwing it on, but the factory seal that's still on the door doesn't have screws. How should I put this one on?

Thanks for your time, Gary.

To remove hatch glass take a razor and cut the lip of the gasket almost all the lip, then u can push the glass out