Stainless steel header??

[ezzzzzzz]

I have done a small amount of searching and surfing on this to no avail. Does anyone make a SS header for the early Z's? All I've found is plain and coated.

[2-4-T-Z-MAN]

I don't know that I've seen them either. Why do you want SS? You can get ceramic coated silver that will polish up and hold the shine. Mine have been on the car for 3 years and look as good as the day I got them.

[ezzzzzzz]

I've run the ceramic coated headers. Some are better than others and preparation is critical. None have ever lasted as they should unless the car never saw rain and was parked in a low humidity garage. I found they rotted from the inside out in most cases.

I did pick up a JanSpeed SS header on Ebay. They are darkened from use but that causes no discernable problems. JanSpeed warrants their SS headers for life. It won't apply to me since these are secondhand. It can be seen in my gallery. Other pictures of my project can be seen under "ezzzzzzz" at www.hybridz.com so enjoy.

[v12horse]

There are various Japanese companies that make stainless steel headers for the L-series, but I do not believe that they sell one that would fit a LHD car. I know of Fujitsubo and Spirit Garage that make those. However, Stahl might make a SS header for a LHD L-series powered car. You might want to check into them. I hear that they really know their Z's and the headers are of very high quality.

I am sure that there are more companies that make a header you are looking for, but I don't know the names of the companies.

-Ben

[Cruez]

Quite a few now coat the inside as well as the outside. Cooler temps and less to worry about rusting from the inside out.

[ezzzzzzz]

Stahl makes a 240Z header (plain steel) for $775...OUCH! Fujitsubo makes them for around $ 520 to $700 (if I converted correctly)... OUCH again.

I can't translate all of the lingo so I don't know if these are SS or not. It makes my JanSpeed purchase look good. I'll have about $400 in them when it's said and done.

[NZeder]

I purchased the Fujitsubo system - stainless steel. However my zed is a RHD so I don't know if they will work with a LHD car. See the following thread.

http://classiczcars.com/forums/showthread.php?t=19104&highlight=fujitsubo

[Ron Carter]

Burns Stainless in Orange County CA can fabricate a stainless header but it will cost you plenty....

How about a BRE header!?

[MikeW]

There are various Japanese companies that make stainless steel headers for the L-series, but I do not believe that they sell one that would fit a LHD car.

Out of curiosity why would that be? I know the throttle linkage is different and the battery and master cylinders are swapped but I thought everything else was the same between LHD and RHD with regard to the engine and manifolds.

[Gav240z]

I believe it's a problem with the steering rack and the rod that goes to the column.

[MikeW]

I believe it's a problem with the steering rack and the rod that goes to the column.

Ah, that makes sense. I forgot all about the steering.

[dhoneycutt]

I purchased the Fujitsubo system - stainless steel. However my zed is a RHD so I don't know if they will work with a LHD car. See the following thread.

http://classiczcars.com/forums/showthread.php?t=19104&highlight=fujitsubo

Did anyone ever get measurements to verify that it would or would not fit in a LHD Zed? I saw quite a few of this style exhaust when I was in Japan quite a few years ago and would really like to replace my system with one if it will fit!