Quick ?:

On a 73 240, how does the Hazard knob (the part you pull on to activate the Hazard lights) separate from the rest of the Hazard switch?

I've got a switch still attached to the metal support structure and I want to remove it so I can fit a new dash skin over the metal support...

The opening in the new skin that corresponds to the Hazard switch is of a smaller diameter than the knob itself of course...

ideas?

Is it just pushed on? I've pulled a little but it did not budge... pull harder?

thanks,

-e

Eric:

I won't pull a Tonya on you and tell you to use the search button.

PUSH in on the knob, TURN the knob slightly, REMOVE by sliding it off.

But do familiarize yourself with the Search feature...

E

Eric,

To have the dash cap fit like a glove, after you glue it in place take your heat gun and carefully heat the edges. Using a flat screwdriver you can manipulate the plastic to conform to the underlying original dash. Don't overheat as it will cause it to shrink.

And as Enrique has already pointed out, you twist the Hazard switch to remove the knob, then using a "fork" you unscrew the retaining ring.

I did use search and found the answer after looking through the manuals for about a half hour. Thanks for the info. Gotta love this site!

Eric:

I won't pull a Tonya on you and tell you to use the search button.

PUSH in on the knob, TURN the knob slightly, REMOVE by sliding it off.

But do familiarize yourself with the Search feature...

E

Bad advice guys. Much more complicated than a simple twist. Better find other advice.

Edited May 8, 201212 yr by dk240z

This is just one other response:

http://www.classiczcars.com/forums/thread6643.html

and if you think it's more complicated.... Maybe it was your switch.

But let others chime in.

E