Purists beware! 350z seat swap complete

[2003z]

Looks great, nice fit. what size angle did you use?

not sure what you mean?

I used 3 spacers in the rear of the pax seat and one in front, and 3 and 0 on the drivers as the front seat height is adjustable.

[jmark]

Car & seats look good Mike.

[=Enigma=]

Nice job Mike. Do you have any pics of the work you did crafting the mounting parts? Or a finished pic from below?

[montoya_fan01]

not sure what you mean?

I used 3 spacers in the rear of the pax seat and one in front, and 3 and 0 on the drivers as the front seat height is adjustable.

I think he's asking what size angle IRON you used.

[2003z]

I think he's asking what size angle IRON you used.

1" angle iron. Unfortunately, I didn't think to take pictures while I worked. I can try to diagram it later though.

[peng155]

Hey Mike...

Do the passenger, and driver sit at or about the same height with the 350 seats??

I ask cause I just installed a set of aftermarket seats in, and I'm not sure if I'll keep them in the Z... I'm now contemplating referbing the seats with the foam, seat webbing, and seat cover kits.

Thanks

[2003z]

Hey Mike...

Do the passenger, and driver sit at or about the same height with the 350 seats??

I ask cause I just installed a set of aftermarket seats in, and I'm not sure if I'll keep them in the Z... I'm now contemplating referbing the seats with the foam, seat webbing, and seat cover kits.

Thanks

with spacers they do. Without spacers they would be just a little bit lower. The seat bottom on the 350 seats extend below the sliders a little, is why.