Panamared Posted May 22, 2006 Share #1 Posted May 22, 2006 Probably this is a common thread but Im new into the Z world (as owner).Whats the average time from 0 to 60 a Z can reach.L24 with headers, electronic ignition system (crane xr3000 and ps 92coil and a triple weber. (my car) Or a similar set up.This must be aprox since no car is the same as the other.Thank You guys. Link to comment Share on other sites More sharing options...
Zs-ondabrain Posted May 22, 2006 Share #2 Posted May 22, 2006 Mine used to be APROX. 3.2 minutes But now I have a stage 2 cam, 6-into-1 header w/ 2 1/2" pipe thru a turbe (Raptor) muffler. MSD 6A, Mallory Unilite Dist. and Mallory Promaster coil. Stock S.U.'s and 79 ZX 5-speed w/ an 83 Turbo 3:90 diff on 225/50R16's Good question though. love to hear an aprox. time. Dave. Link to comment Share on other sites More sharing options...
olderthanme Posted May 22, 2006 Share #3 Posted May 22, 2006 I am guessing mine is around 6 seconds...maybe less once I get the clutch worn in so I can slam the clutch. Link to comment Share on other sites More sharing options...
olderthanme Posted May 22, 2006 Share #4 Posted May 22, 2006 stock was like 10 seconds... Link to comment Share on other sites More sharing options...
Arne Posted May 22, 2006 Share #5 Posted May 22, 2006 Stock '70 240Z (according to Road & Track. April 1970 issue) did 0-60 in 8.7 seconds. In my experience, the engine mods will only cut a little bit from 0-60. Gearing changes will have far more effect. I'd guess that without a gearing change or a turbo, an L24 powered 240Z would be hard pressed to get under 7.5 seconds. But that's just a guess, not a fact or experience. Link to comment Share on other sites More sharing options...
Zs-ondabrain Posted May 22, 2006 Share #6 Posted May 22, 2006 I guess it would also depend on the amount of LEAD in your foot. I KNOW that mine has GOT to be better than 7.5 but maybe it just feels that way. I now have a better reason to go get that stop-watch I've been eye-balling. Link to comment Share on other sites More sharing options...
olderthanme Posted May 22, 2006 Share #7 Posted May 22, 2006 indeed...you have to get a lot of mods that will decrease your 0-60 time. I noticed a huge improvement with my 11# flywheel, coilover suspension with illuminas, and most of the interior gone a big increase in acceleration is noticed. Link to comment Share on other sites More sharing options...
Arne Posted May 22, 2006 Share #8 Posted May 22, 2006 I strongly suspect that your car IS faster than 7.5, Dave. The 3.90 in the rear is probably the key to that.Although - If the gearing gets too low, 0-60 times can suffer. With the stock 3.36:1 ratio and stock height tires a 240Z can make it to 60 with only one shift. If you get too low geared you have to shift again (into third) to get to 60. No matter how fast you shift, that is going to hurt the 0-60 time.Which is why 0-60 is not a really great measure of performance. It is too short a time/distance to allow things to all work together. There are some wicked fast race cars that have really poor 0-60 times (compared to their power output). Link to comment Share on other sites More sharing options...
olderthanme Posted May 22, 2006 Share #9 Posted May 22, 2006 I think the perfect gearing is the 81-83 280zxt tranny mated to a standard 3.54 rear end. That is the way I am going as soon as I get the tranny and other stuff. It lets you cruise at 70 at like 2700rpms... Link to comment Share on other sites More sharing options...
jmortensen Posted May 22, 2006 Share #10 Posted May 22, 2006 Appropriate gearing depends on many different factors, turbo or NA, tire size, powerband of the engine, weight of the vehicle, etc. There is no "right" answer. The T5 maybe perfect for cruising on the freeway at 2700 rpms, but that is the widest ratio transmission you can get for a Z. That's not good for a cammed NA car with a narrow powerband, for instance. Link to comment Share on other sites More sharing options...
Carl Beck Posted May 22, 2006 Share #11 Posted May 22, 2006 Hi Jon:"T-5".... who said anything about a T-5?Carl Link to comment Share on other sites More sharing options...
jmortensen Posted May 22, 2006 Share #12 Posted May 22, 2006 Olderthanme did. 280ZXT transmission is a Borg Warner T5 last time I checked. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now