Fix for Clutch throwout bearing howel?

[Zup]

Just finished with install of all new parts from MSA---

For a early 73 240Z:

Stock clutch

Pressure plate

Clutch collar

THROWOUT BEARING----:mad:

Dust boot

Clutch master, hose, and slave were replaced a few months previously with new parts. Worked fine until the clutch disk lining finally wore out and it would slip under acceleration.

A clutch disk alignment tool was used for the install.

Bearing howels when clutch pedal is pushed in----sometimes quite loud and annoying, sometimes not so loud.

Any fix short of taking it all down and redoing with a new bearing?

Dissappointedly! :disappoin :disappoin :disappoin

Jim D.

"Zup"

[ktm]

Unfortunately no. How can you apply a fix when the part/area that needs fixing is completely covered by the bell housing?

It does seem odd that a new bearing would make noise.

[a7dz]

It would not be the first new bearing that I have seen bad. You may want to also inspect the fork the bearing rides on along with the pivot. Either could be bent enough to put a side load on the bearing. I have replacements for both along with the bearing. I will install them as I put the motor back. I do not want to drop the transmission once I am back together.

[Zup]

Thanks for the replys---

I knew the answer-----wishful thinking??

I will reinspect the fork and pivot on disassembly. They looked fine.

I will also be looking for rough spots on the input shaft.

I suspect that I have been victimized by a "bad in the box" bearing as a7dz stated.

It does happen---but :hurt:

WHY ME?

Jim D.

"Zup"