Jump to content

Welcome Guest! Please read more information about our club!
IGNORED

Oil Sending Wire on Harness

Robin

By Robin
in Electrical

 Share

Recommended Posts

Robin CollaborZator

Robin

Posted
Posted

today i was cleaning the wiring harness getting it ready to re-install into the engine bay and just happened to take the boot off covering the connector that leads to the sending unit and found this extra wire inside the boot. Im not sure where this is suppose to connect to. The wiring diagram in the fsm shows only 1 wire however this lead has two, and the harness only has the bullet connector (female end) to plug into. Any suggestions would be appreciated as usual..... 1973Z

Thanks!!

post-5458-1415080086221_thumb.jpg

post-5458-14150800862512_thumb.jpg

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing
×
×
  • Create New...

Important Information

By using this site, you agree to our Privacy Policy and Guidelines. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.