zanthus Posted August 30, 2007 Share #1 Posted August 30, 2007 Okay so I've finally rebuilt my engine to my 280z and it actually runs. The only problem is the PO had the vacuum lines so jerry-rigged that I have no idea what goes to where. Most of them were not connected in the first place when I got the car. I have searched the Forums found the HVAC diagram and I have the FSM and it really doesn't seem to help too much. Does anyone have a better picture? Link to comment Share on other sites More sharing options...
sblake01 Posted August 30, 2007 Share #2 Posted August 30, 2007 About the best diagram you'll find is in the 78 FSM. It's located on page ET-3. There are some things you can't see like anthing that's underneath what's shown. If you have any questions, I have a 78 the has the correct routing of anything you can't see in the diagram. Link to comment Share on other sites More sharing options...
Jeff G 78 Posted August 30, 2007 Share #3 Posted August 30, 2007 I have a '78 FSM as well as a '76 FSM and I have not found the vacuum diagrams to be very useful. I would love to see a real photo with labels showing each vacuum line and its routing. I have one or two lines on my '78 that I simply cannot figure out. I have looked at the FSM until my eyes went blurry, but it didn't help :stupid:. I also have a '75 parts car to look at for help, but there are too many differences between the years for it to have been of any help. Link to comment Share on other sites More sharing options...
zKars
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now