fuel injector problem

[rzkas]

hi, i have a 1976 280z with an automatic trans. i need help. i bought this car and the owner told me it used to run but it stop runing due to bad feul pump. i went ahead and changed the feul pump. i tried to start the car but car was just cranking but dont start. i went and add more gas. the same problem it crank but dont start. i used a jumper on the battery but same symptoms. i put gas in the intake manifold and the car started. i went on diagnosis the car. i thougth of feul pressure. i took one of the injector out and i tried to start the car but the injector was not pumping /spraying gas out. i went ahead and disconnect the feul line. i asked someone to turn the car on and feul pressure build up. when i tried to release it, gas was spraying everywhere. there is power going to all injectors. pls help me fix this car and have it running. i have change the feul pump. feul filter, starter and a new battery. help pls. thanks

[Friar-Tuck]

Here is a link to the factory service manual for a '78 car. (edited out)

There should be several "Test" procedures that should help. There's lot's of fuel injection stuff in the archives, (I know its tough to find somewhere to start)

Read through the section on the fuel injection in the service manual (as per SBlake linky) and I'll try to find the link to the nissan fuel injection book.

Tuck \o/

(DoHH! it was right below the previous link!)

http://www.xenons30.com/files/280zfuelinjectionbook.pdf

Edited November 6, 2008 by Friar-Tuck
Wrong year FSM/found F.I. manual

[sblake01]

His is a 76 and your link is for a 78. Here's the link to the 76 FSM:

http://www.xenons30.com/files/FSM/76_datsun_280z.zip

[Friar-Tuck]

Brother your fast! I tried to fix it

SBlake, I hate to admit it and you know I do....

You're Right Again!

Tuck\o/

[rzkas]

Thanks for the info

[Benderz280z]

rzkas, good morning! i have a 77 280z. My problem is I have replaced tank, pump and filter. My car is also a automatic. I can drive and when it gets sort of hot it will sort of cut off, sounds like fuel not a overheating issue. Do you have any suggestions?

[rzkas]

hi, sorry for the late response. i dont know but i will look up info and i will get back to you.

[Friar-Tuck]

DBender,

here is a zip file for the '77fsm.

This should help. http://www.xenons30.com/files/FSM/77_datsun_280z.pdf.gz

Tuck\o/