Jump to content
We Need Your Help! ×

IGNORED

Running to Rich and Flooding out!!


nissan280z

Recommended Posts

I have a 1977 Datsun 280z, since i bought the car it ran good but once in a while it runs rich and starts to flood out. When i give it gas it starts to sputter.I been trying to find this problem for a while now and i cant figure it out. People tell me its the water temp. sensor, i changed it and it still does it. It seems like the problem will go away for like a week but then it comes back, I'm thinking it could be a relay, but i don't know what it is, Can someone please help me! Thank You.

Edited by nissan280z
Link to comment
Share on other sites


There's been a number of posts on this issue. Many things could cause this. Leaking injector, leaking cold start valve, bad thermotime switch which would cause the cold start valve to work when it shouldn't, bad throttle valve switch, water temp sensor as you mentioned, fuel pressure regulator, bad connections at any of the above mentioned items. Do you have a factory service manual? It has step by step troubleshooting instructions.

Link to comment
Share on other sites

In all of this work switching parts out, did you take the time to clean thoroughly all the connectors? What condition are your pigtail connectors? How about the connectors that go to the thermotine, water temp sensor, etc...? Can you just push them on and pull them off easily? If so, you probably have crud or looseness in there that causes bad connections.

Think about it: You fiddle with things (and end up getting a good connection) and the car runs. After running for a while, the connections loosen up, and you are back to having the same problem.

It's not hard, nor does it take much time to go and check them and clean them out really well.

If nothing else, doing this will help shorten the list of possible causes.

Link to comment
Share on other sites

i put alot of time into my car ive cleaned the connectors to......but when it starts to sputter and running rich i pull the spark plug wire that goes to the coil to see the spark! wheal it steel running ! it clears up. and i even bot a new coil. and distributor to!! i practically changed everything.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Who's Online   1 Member, 0 Anonymous, 313 Guests (See full list)

×
×
  • Create New...

Important Information

By using this site, you agree to our Privacy Policy and Guidelines. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.