Jump to content
We Need Your Help! ×

IGNORED

71 240z hatch strut mount


darr3239

Recommended Posts

OK. I'm now beating my head against the wall, after conducting numerous searches. My 240 is missing the bracket/mount, whatever you call it, where you attach the bottom of the hatch strut. The early Zs only had one strut, which probably caused a lot of the mounts to break off? I only see two holes where it once was. Was it attached with a bolt, screw or welds? I need a new on so my hatch won't decapitate me!!! Help

Link to comment
Share on other sites

The hatch support cylinder mounts with two bolts to the hatch itself. On the body end, there should have been a mount tab welded to the body that has a single hole in it. The cylinder has a pivoting bracket that bolts into the mounting tab. I attached the only picture I could find of the body tab.

post-8596-14150806468354_thumb.jpg

Link to comment
Share on other sites

It is one of those things that i have been hunting down and finally got one, loads of pics here.

I was suppose to get one from member "jcote" but it never worked out, he might still have it.

Chris

post-14427-1415080647167_thumb.jpg

post-14427-14150806471761_thumb.jpg

post-14427-14150806471877_thumb.jpg

Link to comment
Share on other sites

  • 4 years later...

havn't seen the bracket sold by itself. Mine actually just popped it's weld over the weekend and came off. I was able to clean it up and screw it back into place through the hols where the weld was alond the drip rail in the hatch. If you do not have the bracket at all the only thing I have seen receintly is...Zeddsaver selling this on ebay.

Datsun 240Z Rear Hatch Strut | eBay

You could email Norm at Zeddsaver tosee if he sells just the bracket.

his email address: zeddsaver@zeddsaver.com

~Taz0162

Link to comment
Share on other sites

Have gone through this problem also. They are spot welded in 3 places, 2 on the drip rail and one on an inner piece of metal. Make sure it goes back in the same place so the strut operates properly & the inner panel cutout lines up. Spot welding the rear spot will not damage any outer paint, but the 2 on the drip rail will, so some paint repair, the weather striping will cover it.

Bonzi Lon

Link to comment
Share on other sites

My problem is the vehicle is completely missing the part. It looks like it got some rust in that spot and it broke off. I am planning on getting that piece cut out and re-welded but I don't have the replacement bracket. Maybe someone could measure the dimensions and I could pay for the welder to fab up a replacement piece?

Link to comment
Share on other sites

  • 9 months later...

Your best bet (besides resurrecting a very old thread) is to search Ebay, Craigslist, or the classifieds here or on Hybridz.org. Hybridz routinely has part out threads and you could post in such thread asking for the part, or go to the Parts Wanted section and start a new thread.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Who's Online   1 Member, 0 Anonymous, 202 Guests (See full list)

×
×
  • Create New...

Important Information

By using this site, you agree to our Privacy Policy and Guidelines. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.