Jump to content
Email-only Log-Ins Coming in December ×

IGNORED

Need to raise the rear end a little


81 ZXT

Recommended Posts

My 81 ZX sits too low in the rear. I installed new front struts and rear shocks. The front end lifted nicely but the back is too low. When you are looking at it there is no gap between the wheel well and the tire. Could my springs be worn out and if so where to buy? Car has 158K miles and I just dont think the coil springs could be worn out but that is the only thing that holds the body off of the rear axle. Any suggestions?

Link to comment
Share on other sites


My 81 ZX sits too low in the rear. I installed new front struts and rear shocks. The front end lifted nicely but the back is too low. When you are looking at it there is no gap between the wheel well and the tire. Could my springs be worn out and if so where to buy? Car has 158K miles and I just dont think the coil springs could be worn out but that is the only thing that holds the body off of the rear axle. Any suggestions?

I believe that insulatiors(at the top of the springs) are available from MSA for that.

If not you need a set of new springs.

Esprist

www.jdm-car-parts.com

Link to comment
Share on other sites

Well Stephen you were right again. Installed the new springs last night and it raised the back end by about 3 inches (looks good). Also stiffened the ride back there. I didn't realize how spongy it was until it wasn't anymore.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...

Important Information

By using this site, you agree to our Privacy Policy and Guidelines. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.