Jump to content
We Need Your Help! ×

IGNORED

Easiest way to remove tacho from '72 240Z?


alhbln

Recommended Posts


If there's a way to get the tachometer and speedometer out past a full dash cap, I'd like to know!

It can't be done with a full dash cap without damaging the cap. That's why the glove box and the heater control panel need to be removed in order to remove or install the tach and/or the speedometer from the rear.

Link to comment
Share on other sites

I recently pulled my tach from the front-just the 2 wing nuts, which I loosened with lineman's pliers. There is enough wire length to disconnect the harness from the front hole after you pull it. Getting the nuts back on may be a bit more difficult.

Link to comment
Share on other sites

  • 8 years later...

 I'm going on what I've read. It appears that the speedo has two wing nuts that are accessed from under the dash. One wingnut on the top, one on the bottom. It's been reported that they can be difficult to crack them loose. After removing the wingnuts and disconnecting the wiring, the speedo pulls out from the front. If you have a dash cap it will be difficult to get the speedo out but it's possible. Good luck.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Who's Online   2 Members, 0 Anonymous, 797 Guests (See full list)

×
×
  • Create New...

Important Information

By using this site, you agree to our Privacy Policy and Guidelines. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.