Jump to content
Email-only Log-Ins Coming in December ×

IGNORED

Rocker arm, pivot wear


tanny

Recommended Posts

I was adjusting the valves on on my 73 240 and noticed that the rocker arm pivots have a large variation in their height in relation to the head, causing the angle of the rocker arms to vary significantly with respect to the cam lobes(I assume due to wear). All were adjusted successfully, but a couple of the valves were getting close to the point where I will not be able to adjust them(not enough room for two wrenches) if there is much more wear on pivot and/or rocker arm. The head just received a valve job and all springs replaced. Is it necessary to replace the rocker arm or the pivot or both? Which part usually wears out first(lash pads, cam lobes, and rocker arm wipe surfaces look fine)? Thanks, Victor.

Link to comment
Share on other sites


Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Who's Online   0 Members, 0 Anonymous, 420 Guests (See full list)

    • There are no registered users currently online
×
×
  • Create New...

Important Information

By using this site, you agree to our Privacy Policy and Guidelines. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.