I'm trying to put this car together and the leads I had on these pieces have gone cold. Anyone know where I could get these carb linkage parts?

Have you checked with Bruce at Z Therapy?

A much less complicated throttle system, is a cable linkage such as Lokar. Go to Arizonazcar.com and look for 4-barrel manifold install. Sorry i don't have quick link.

You could also try Roger at ZBarn.

Thanks guys. I spoke with Bruce and sent Roger an email. That is a good idea on the cable, and probably the quickest and the lowest cost solution, but I am inclined to get a working mechanical solution.

If you have no luck with Bruce or Roger, PM me. I am sure I can dig up what you need.

Dan

It can be figured out, here are some differences I ran across:

Top yellow line: different lengths depending on the lever to the right, can be adjusted.

2nd yellow line: same bracket, some have 20mm spacers behind depending on the length of

3rd yellow line: this rod, different lengths depends on which balance tube being used

4th yellow line: should be attached to above

5th yellow line: different lengths depending on carb spacers

I was lucky enough to have plenty of parts to choose from to make my carb swap work.

Bonzi Lon

Hey Bonzi, I think that no matter what, I will need to be doing some cutting and welding to get the lengths right. Hopefully one of the sources I am pursuing will come through.

www.piercemanifolds.com/category_s/32.htm.com

Edited June 10, 201113 yr by ezzzzzzz

You can replace with a DIY cable system from a junkyard donor car and some figur'n