Jump to content
Email-only Log-Ins Coming in December ×

IGNORED

Throttle stuck and now the engine won't stay running.


M.Gwizdek

Recommended Posts

Hey Guys,

Today on my way home from work the throttle stuck momentarily on my '71. The RPM's shot up quite high (I have no idea how high as I was more concerned with getting the pedal to unstick) and a plume of smoke came out of the exhaust pipe. After that the car seemed to run okay until I got off the highway. At the stoplights the engine kept dying. I was able to crank it over by giving it some gas and keeping the RPM's up, but as soon as I let off the accelerator it would shut off.

Any ideas?

Thanks,

Mike

Link to comment
Share on other sites


What type carbs?

Why did the throttle stick?

What color was the plume of smoke?

Carbs been rebuilt?

Daily driver?

Smell like fuel?

Sounds like it's running out of gas?

History on the car?

Answer all the above questions and then continue posting;)

Link to comment
Share on other sites

What type carbs?

Why did the throttle stick?

What color was the plume of smoke?

Carbs been rebuilt?

Daily driver?

Smell like fuel?

Sounds like it's running out of gas?

History on the car?

Answer all the above questions and then continue posting;)

Twin SU type carbs.

The carpet caused the throttle to stick.

The plume of smoke was white.

I've owned the car for about a year now, I can only say that I haven't rebuilt them. I don't know if the previous owner had.

I'd say the car is a daily driver during the nice months of the year on days with good weather.

No fuel smell.

Doesn't really sound like it is running out of gas, just dies at low RPM.

As previoulsy stated, I've only owned the car for a year so I don't know much if any history on it. It has always run well for me.

Thanks for all the replies. I will check the compression tomorrow after work and will report back.

Mike

Link to comment
Share on other sites

He might just mean comparing the cylinder pressure readings between cylinders. It's more important than the actual pressures. All cylinders should create the same pressure, within ~20-25% lowest compared to highest according to the FSM and the Monroe rebuild book (although most people recommend a tighter number). For example, I've had two engines that tested within 2 psi, high to low, at about 175 psi for one and 180 psi for the other. The gauge used will affect the pressure measured though so the comparison is what's important.

If you do find a pressure imbalance, a leak-down test would then give you more information about whether it's the head gasket, the rings or the valves.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...

Important Information

By using this site, you agree to our Privacy Policy and Guidelines. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.