where to connect some wires of the 240Z

[datsunnyit]

Hi all ,

I do not know where to connect some wires of the 240Z.

Can you help me?

http://www.flickr.com/photos/13763559@N05/

http://www.flickr.com/photos/13763559@N05/8238186955/in/photostream

http://www.flickr.com/photos/13763559@N05/8239254952/in/photostream

http://www.flickr.com/photos/13763559@N05/8238186635/in/photostream

http://www.flickr.com/photos/13763559@N05/8238186293/in/photostream

thanks

Franco

[240260280z]

http://www.flickr.com/photos/13763559@N05/8238186293/in/photostream goes to a condensor

[240260280z]

http://www.flickr.com/photos/13763559@N05/8238186955/in/photostream gets bolted to the wheel well wall just above where the harness ties in. It is a chassis ground.

[jfa.series1]

Franco,

I'm using my car as a guide on this, a '71 240Z.

Photo 3-copia is for a condenser that is part of the voltage regulator.

Photo 2-copia two holes are correct

Photo 1-copia not correct! There should be a green/white wire coming from the harness that attaches to the ballast resistor. A black wire with female spade connector goes to the (-) on the coil, a black/white wire with female spade connector goes to (+) on the coil. You should also have a condenser attached to the (+).

Photo 0-copia this is a ground wire to the body. Look for a hole in the inner fender just above the hold-down for the wiring harness

Hope this helps.

Jim

[datsunnyit]

Hi thanks for answer, how much the capacity , uF ( microFarad ) has the condenser ?