Antenna Rebuild / Restore

[cbuczesk]

I have that rubber part too.

Chuck


Sent from my [device_name] using http://Classic Zcar Club mobile

[nix240z]

1 hour ago, cbuczesk said:

I have that rubber part too.

Chuck

I have a good sample....

 

3 hours ago, cbuczesk said:

I found a really nice one. It's still very soft.

Chuck

This is the one I don't have a great sample of.  The one I have has a few groove marks on the underside from the grounding ring.

[JLPurcell]

If the mast could be reproduced with the correct tip it would be a no-brainer to have at the very least 100 reproduced. What is the cost per unit? I had forgotten about the seal ring under the retainer. I hope that along with the cap Nix can reproduce this part. With the mast and the rubber parts correct restoration of an antenna for the early Z will be possible. 

Edited January 23, 2018 by JLPurcell

[cbuczesk]

Steve - I'll send you the rubber part from my picture. Is there anything else needed for the antenna?

Chuck

 

[drpchuynh]

I would be interested in a few.

Sent from my [device_name] using http://Classic Zcar Club mobile

[Galaxybj]

Same here

Sent from my [device_name] using http://Classic Zcar Club mobile

[Mike B]

I'd also be interested in several sets.

Sent from my [device_name] using http://Classic Zcar Club mobile

[ajmcforester]

For the mast, the tip and how the cord attaches on top are the only different things. The tip will fit the reproduction mast. The upper rubber and chrome cap seem hard to find in good condition. Beyond my discription I posted on replacing the cord and rebuilding the motor

Sent from my [device_name] using http://Classic Zcar Club mobile

[nix240z]

I worked my magic and have these ready to reproduce.  One is plastic and  the other is rubber plus the small finisher nut rubber seal.

Should be about a week before I get some samples ready.

I will update once I get them finished.

 

 

[JLPurcell]

43 minutes ago, nix240z said:

I worked my magic and have these ready to reproduce.  One is plastic and  the other is rubber plus the small finisher nut rubber seal.

Should be about a week before I get some samples ready.

I will update once I get them finished.

 

 

 

I would like two complete sets, these parts along with the retainer nut cap piece. Thanks for making these available!

I will take a look at your site it has been awhile since I ordered I probably will order a couple of other pieces. 

Edited January 24, 2018 by JLPurcell

[JLPurcell]

This is a members antenna that I am helping him to restore. I an now awaiting the rubber parts. JLP

[nix240z]

Update.. I have sent a sample set to Zup for his review and opinion.