Twice tip muffler.

[moelk]

Hi.

I going to build a muffler for my 240z like the one on the z432 or the one from Fujitsubo. Can someone give me the measurement of the two end pipes? Diameter, c/c and the degree of angel they are cut.

Thanks/

Andreas

[surfer.tech]

The Fujitsubo unit is a twin pipe all the way from the header.

I believe the tips are 48mm. The rest of the pipe is 48mm. The angle is a slashed cut, very similar to a motorcycle exhaust.

I have one and a few other members on here as well. Unless your a welder or know of one, it might be cheaper to just buy it.

[moelk]

Hi surfer.tech.

I have everything i need, just in need of the measurement.

Its just the muffler i will do. Welding will not be expensive for me. The c/c is importent to make it look right i think. If you have the time could you get it for me? Thanks

[surfer.tech]

I wish I could help you out but my car is now in storage for the winter.

If you want some photos, I do have them. Send me a PM with your email and I'll send you some.

Maybe spitz can chime in.

[HS30-H]

Some sizing data in this old thread:

http://www.classiczcars.com/forums/exhaust-s30/28457-twice-pipe-exhaust-system.html

[riceburner]

Here's the dimensions of my Twin 60mm stainless can from Reinhard Japan, It is twin 60mm inlet and outlet. Excuse the rough diagram, I had already done this for a fellow member on Auszcar. Hope it helps.

[moelk]

Thank you all. Just what i was looking for! Now i have something to do when the winter comes.

PM sent to you surfer.tech