Jump to content
Email-only Log-Ins Coming in December ×

Welcome Guest! Please read more information about our club!
IGNORED

Rack and pinion help.

timsz

By timsz
in Suspension & Steering

 Share

Recommended Posts

EuroDat GrandMaster Z

EuroDat

Posted
Posted

Its the rubber bump stop. I would assemble it like you have in the photo in post #1. Adjust the ball joint like Captain said and tighten the lock nut. Then you can turn the bump stop by hand until it reaches the lock nut. I don't think the rubber will take much tension, so hand tight will be enough.

These bump stops look thicker than the ones I have and have seen. The ball joint section could be shorter to compensate for this. If not the bump stop could have an effect on the rack stroke 60.7mm which in turn will effect the turn radius a bit.

Chas

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Recently Browsing   0 members

    • No registered users viewing this page.

  • Who's Online   1 Member, 0 Anonymous, 766 Guests (See full list)

×
×
  • Create New...

Important Information

By using this site, you agree to our Privacy Policy and Guidelines. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.