My Datsun 280Z "Rustoration"

HaZmatt · February 27, 2015

I installed my MSD box today. Still need to run a couple more wires but its pretty straight forward. I mounted it in the drivers kick panel where the EFI unit was.

First I mounted the insulators

Then the box. It fits nice in there

Heres a couple shots of my engine bay. I still need to tidy things up and route my fuel lines better.

takayuki · February 27, 2015

what are you doing for the crankcase breather (the one under the thermostat housing)? Did you just cap it off or are you venting it some other method?

CoeGuthrie · February 27, 2015

Looks so good Matt!

And thanks to all for the input. I'll try the Eastwood product and if I have to try a more dire route someday, then so be it.

I sincerely hope this is the 90% I didn't see!

HaZmatt · February 27, 2015

what are you doing for the crankcase breather (the one under the thermostat housing)? Did you just cap it off or are you venting it some other method?

Using an oil catch can mounted next to the radiator.

wheee! · February 27, 2015

You should add a 90 degree fitting at the crankcase vent output an then route the hose towards the front of the engine and then over to the catchcan. Maybe you could find a preformed hose with a 90 in it already.... That would be nice!