HELP!!!! Car cutting out on acceleration

[HermanM]

I just took out my fully rebuilt 260z for an "around town" trip that was longer then usual. The issue I am have is that when I parked my car and then got back into it, I had issues accelerating.

It almost felt like one of the carbs may have been cutting out and I was revving up pretty good with no great acceleration. As I would stop and go, it was come and go, but when I went to get onto the freeway I topped out at 70mph with the engine making a loud slurping noise.

I have no idea where to start looking and this car has to make the 800+ mile drive to ZCON in a week and a half. Please help.

Info on Z:

Stock L26 (all emissions taken off professionally) and Manual Transmission

Early SU carbs

No ac running

car only has 300 miles on it since the rebuild

[siteunseen]

Maybe some loose nuts around the carbs? I'm sitting here making Slurpee noises and to me it sounds like sucking in air?

[HermanM]

it's like a gurgling sound

[madkaw]

So a little history please. Was it running fine before?

Might just start looking at the basics and going from there.

Check for tightness of all fasteners , return springs , linkages.

[conedodger]

Gary built it. Take it to Gary before it makes a popping sound...

[HermanM]

Maybe some loose nuts around the carbs? I'm sitting here making Slurpee noises and to me it sounds like sucking in air?

Bolts are tight and hoses are great

[HermanM]

So a little history please. Was it running fine before?

Might just start looking at the basics and going from there.

Check for tightness of all fasteners , return springs , linkages.

Was running perfectly and everything is tight as can be

[HermanM]

Gary built it. Take it to Gary before it makes a popping sound...

I've been on the phone with him, on and off, for hours today and run through all the "basic" issues. I am going to replace the fuel pump in the morning to see if that may be the issue

[Stanley]

Loose spark plug?

[HermanM]

Loose spark plug?

nope, all good there

[bartsscooterservice]

bad fuel ? Check spark, ignition timing and fuel supply first.

Are the carburetors not overflowing ?

[HermanM]

Changed out the fuel pump and no more problems. Seemed to have oil or something coming off the bottom of the gasket, but I'm assuming that was the oil used to lube it up upon install