Jump to content
Email-only Log-Ins Coming in December ×

IGNORED

Help! Please Help Me Identify This Part.


The osteopath

Recommended Posts

My 1970 1st gen Z project was running great, my technician friend installed LEDs in the dash, and a couple other things- he came upon this part, which did not appear to be attached to anything,mans he thought it was part of an old mod- there was one ground wire going to it. He removed it, and now car runs in idle, but if I drive, it will make it for about a quarter of a mile, then stall dead. Then won't turn over without a charge. What the hell is this piece? Or is it just a coincidence and related to something else?? Please help!!!!!

post-29637-0-51899200-1417393475_thumb.j

Link to comment
Share on other sites

Somebody took the cover off of a the shunt used on cars with ammeters a while ago and I remember being surprised to see that there was a fuse inside.  Maybe it's an early model shunt?

 

I would guess that it's just coincidence, and that one or more of the "couple other things" that your friend worked on might be the problem.

 

The obvious question is - if he puts it back in, does the car behave normally?  You didn't really indicate if everything was okay until he removed the mystery part.  Also - what did he do with the wire that was attached?  Maybe it wasn't a "ground" but it's powered and killing your battery via short circuit.

 

In general, and your friend should know this, you should not remove parts until you understand what they do.  Especially if there are wires connected.  Also, in general, do one thing at a time.  Confirm that no problems have been created, then move on to the next project.  Now you have the classic " I did five things at once and one of them created a problem" problem.

Link to comment
Share on other sites

Could be that you have a weak battery and an alternator that is not charging.  I would check voltage at the battery with the engine off, then with it on.  The simplest test to see if the alternator is charging.  

 

It may be that he accidentally disconnected the L wire to your voltage regulator.  No L, no charge.  Whatever the reason, if you determine the alternator is not charging, make sure the VR has what it needs to work right before you replace either the VR or the alt.

 

What does your ammeter show before and after the engine is running?  Another tool to use, if you don't have a handheld voltmeter, although not as accurate.

Link to comment
Share on other sites

That part is not a meter shunt, at least not a factory one. The 240Zs all have direct reading ammeters, no external shunt. The 260/280 shunts have two fuses, one on each side of the shunt.

 

The ground wire that was on the mystery part; does it go to ground (car body, etc.) or to a component? Perhaps it needs to be grounded?

Link to comment
Share on other sites

Whatever it is, it looks like it's been broken for quite a while.  The other half of the fuse holder and its plastic base are gone.  I notice many mentions of "heat glass" in the various wiring schematics.  Is that Datsun-speak for fuse?  Maybe one of the heat glass parts offers a clue.

 

Since it's been broken, even with a wire attached, it may not have had any function.  Probably a red herring.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...

Important Information

By using this site, you agree to our Privacy Policy and Guidelines. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.