Jump to content
Email-only Log-Ins Coming in December ×

IGNORED

1976 280Z Restoration Project


wheee!

Recommended Posts


So I have realized that the bigger the sand blasting cabinet, the better. Mine is quite large but a 4-5’ cabinet would definitely be a much better asset. It’s hard to turn the larger objects to sand blast accurately and the light is less evenly spread in a tight cabinet. Lessons learned!

Link to comment
Share on other sites

I have a benchtop-size cabinet and have the same opinion.  Bigger is better.  The makers of my cabinet were clearly focused on their bottom line, because there is not even a centimeter of excess air hose length provided between the siphon tube and the gun.  As for there being any visible lighting inside the cabinet, I gave up on that hope long ago.  I do all my blasting now by feel.  It's impossible to see through the cabinet's hatch window unless I replace the plastic-sheet overlay for every job (no thanks).  The puny little fluorescent light provided by the manufacturer doesn't do much to help.

All that aside, the blast cabinet is w-a-y more effective than sandpaper or wire wheels when it comes to de-rusting steel parts and getting them ready for primer and paint.  Does a nice job on aluminum castings, too, provided you're careful to mask off any machined surfaces.

  • Like 1
Link to comment
Share on other sites

I added some sealed halogen floodlights in the corners of my blasting cabinet. Also I spaced the glass and mylar sheet up about  a 1/2" with a double mesh of metal window screen below it. It helps deflect the media and it stays clear much longer. I would love to have a larger cabinet but the cost escalates quickly with size. another trick is to blast with the shop lights off.

  • Like 1
Link to comment
Share on other sites

I also made some other modifications to my blasting cabinet. I siliconed every seam I could. I built a dust cyclone out of two 5 gallon buckets which are connected to a shop vacuum. So my cabinet never clouds up. The only downside is the vacuum could be quieter. When the media seems low I just empty the cyclone back into the cabinet. The filter sees very little dust because of the cyclone...

  • Like 1
Link to comment
Share on other sites

17 hours ago, Patcon said:

I also made some other modifications to my blasting cabinet. I siliconed every seam I could. I built a dust cyclone out of two 5 gallon buckets which are connected to a shop vacuum. So my cabinet never clouds up. The only downside is the vacuum could be quieter. When the media seems low I just empty the cyclone back into the cabinet. The filter sees very little dust because of the cyclone...

hmmm...  I tried just hooking my shop vac up to the cabinet so as to help reduce media 'air pollution' my workshop.  It didn't seem to work very well, so I dropped the idea and switched to setting the cabinet up on a workmate in the back yard.  It never occurred to me that that the vacuum hookup might also serve to reduce clouding inside the cabinet, so thanks for the tip.  I think I'll continue to only use the cabinet outdoors, though.  I've done enough damage to my lungs over the years without adding silica dust to the mix.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...

Important Information

By using this site, you agree to our Privacy Policy and Guidelines. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.