Spare Tire cover warped

[Chickenman]

Any one have any tips on how to flatten out a warped Spare Tire cover? Mine was in good shape, but I had a Tail Gate water leak and particle board cover got wet. As luck would have it, my Tool Box was sitting on top and warped the cover.

 

Cover is in really good shape, and I'd just like to flatten it out. I was thinking one of those Steam heaters and then some weight on top, or maybe wetting it down again and putting a sheet of Plywood and heavy weights on top? Your thoughts folks? TIA

[psdenno]

Steam might work.  You could try getting it wet again and then pressing it flat while it dries.  If it gets too wet, the particle board will start to disintegrate, so be careful.

Dennis

[Oiluj]

Might try using a hot clothes iron on it.   Place a very lightly damp cloth between the iron and the particle board so it doesn't leave residue on your wife's steam iron!

[Chickenman]

Might try using a hot clothes iron on it.   Place a very lightly damp cloth between the iron and the particle board so it doesn't leave residue on your wife's steam iron!

 That's one idea I was also thinking about. I think I'll give that a go.

[DatsunZGuy]

The thread below seems to imply that fixing it would be difficult.

http://www.djchat.com/showthread.php/57023-Un-warping-particle-board

I had a damaged spare tire cover and opted to ordering a replacement from MSA for about $40.00.

[takayuki]

Techno toy tuning also has a nice spare tire cover for our cars as well. A metal one.

[Redwing]

I would dampen it, then lay it on concrete, and place a wheel of your car on the bulge, letting pressure do the job.

I am serious, not joking.

[ajmcforester]

OK that is made from interior grade particle board or also called interior hardy board.  The problem in when it gets wet the glue in the material seperates. So avoid moistue it will brake it down more.  I'd use wight and presure to flatten, the iron idea is not bad, but remember the glue in the board burns at low temps also.  If that dont work make a new one you can buy exterior and interior grade at the big box stores.

[jonathanrussell]

This doesn't directly answer your question but you may be interested in knowing that MSA sells a reproduction.

 

http://www.thezstore.com/page/TZS/PROD/classic01a/50-5350

[Chickenman]

We'll see how the flattening goes. If that doesn't work I'll probably order the MSA cover. Thanks to all for suggestions.

 

Just got back from a local car show. 1,200+ cars.. but got a bit too much Sun. I look and feel like a boiled Lobster....ugh.

Edited June 22, 2015 by Chickenman