Jump to content
Remove Ads

Featured Replies

Just replaced my fusible link yesterday, which was kindly sent to me by Michael Mcginnis at Banzai Motorworks. The male connector was not bad, so i just cleaned it with a brass brush wire and replace the plastic Shell. The female which is attached to the starter was fully replaced as it appeared to have taken a lot of heat.

 

Anyway, while craking the car out of the parking in reverse and sliding 1st, i did notice the car coughs and presents a slight hesitation. Not as it used to before, but still some hesitation. Is this normal when the car is cold? I have deleted all of the emission crap on top and asides of the balance tube. Could this be cause of this coughing and low rpm hesitation?



Remove Ads

Create an account or sign in to comment

Remove Ads

Important Information

By using this site, you agree to our Privacy Policy and Guidelines. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.